Tap design pressure... | UK Plumbers Forums | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Tap design pressure... in the UK Plumbers Forums area at Plumbers Forums

Messages
7
Hi guys, happy new year to all.

Anyone able to explain to me the cons of fitting taps designed for high pressure on a gravity fed supply?

I'm currently doing my bathroom, but don't want taps designed for low pressure as I'm planning on having my cylinder swapped out in a few months and going mains pressure everywhere.

If I install high pressure designed taps (non thermostatic) am I right in assuming that they'll work fine for the time being as an interim measure?

Thanks!
 
They'll work but you could probably p faster. Depends on current height of header tank above the taps.
Not a lot unfortunately, probably a couple of meters max above the level of the taps!

Pee flow is fine as a temporary measure, been staying at the mother in laws where the mains pressure is so bad that you have to start the bath 15 mins before you want it...

At least it will be a constant reminder to get the cylinder swapped out
 

Similar plumbing topics

  • Question
How high is the hill 40m as that will add 4...
Replies
2
Views
503
  • Question
Thankyou, I have already installed a hot and...
Replies
13
Views
1K
  • Question
would this be legit...
Replies
1
Views
1K
  • Question
Has anything been changed, or added recently?
Replies
4
Views
1K
Deleted member 120897
D
  • Question
Thanks for the responses, I'll be on the phone...
Replies
5
Views
859
Back
Top