Thermodynamic box - cold water | Bathroom Advice | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Thermodynamic box - cold water in the Bathroom Advice area at Plumbers Forums

Messages
6
Moved in to our house last year with thermodynamic pump on the hot water tank. It pretty much takes water from the top outlet of the hot water tank heats it up in the box and returns to the bottom of the tank. It worked fine but just had our boiler replaced and changed hot water tank to unvented. The box only cuts in after temp has dropped, it works correctly but my problem is when it’s running it ‘steals’ my domestic water which makes it cold at the taps/shower. Any advice or ideas that I could do to stop this happening. There are valves on the box and I’ve tried throttling them in but makes no difference.
Thanks
Mark
 
any pics of said box?
 
It’s underneath hot water cylinder

A979AFC9-03A4-4B11-9E15-AC3492167DB2.jpeg
 
i would say your missing a check valve on the cold to the pump

im guessing you have a panel on the outside

also im guessing its teed in to hot outlet instead of the secondary port
 
Correct, the panel is on the side of the house as it’s a refrigerant gas it’s the ambient air that heats it.
I’m sure there’s a non return valve inside the box. It’s doing the right job in that it’s circulating the water in the cylinder and heating it up, it’s just when I run a tap and as the box pump cuts in the hot water chooses to flow back through the box rather than to my taps. I’ve just been turning it off while showering and then back on after for now.

99489DB0-019A-4264-99D7-7E9F61E08408.png
 
i would say needs to go into the secondary return port / connection

also i would say the stat wire is in the wrong pocket
 

Similar plumbing topics

  • Question
IME Mira showers of that age are usually very...
Replies
1
Views
620
  • Question
That's not what I meant. Are the hot and cold...
Replies
6
Views
1K
  • Question
Many thanks for your advice I will get up into...
Replies
3
Views
493
R
  • Question
I just had installed a Navien NPE-2 with built...
Replies
0
Views
538
Rogelio
R
  • Question
Yours is an old fotic cylinder, Thermal store...
Replies
1
Views
1K
Back
Top