Thanks in advance for any advice.
have moved recently into new house (London hard water area) and want to install a second garden bib tap to serve the front garden. No issue there can take a run of pipe within the garage to the front.
Ive noticed though the tap at the back garden is run off the water supply in the utility room. All of the house water supply comes via a BWT salt water softener unit. So basically I am watering the back garden with soft water and wasting my salt.
I can run a new line to the back from the garage to the wall in the utility room and connect the back garden tap to the hard water supply in the garage (ie before the water softener unit).
To connect to the bin tap union connection within the utility room is a bit (a lot) fiddly as the current pipe comes into a sink unit. Can be done but I’d have to remove the current wallplate flanged pipe and replace with a straight pipe and a wall plate elbow outside to be able to pull the pipe in make the connection inside and then push the pipe out.
But one thing we do from time to time is fill the hot tub (1500 litres) and think this might be better to do with soft water so what I was thinking is maybe introduce a T with two isolation valves one from the current soft water line and one from a new hard water line.
is that allowed? Is there a better way to do this? Or should I just leave the current set up and put in a second bib tap at the back so the two lines don’t mix? Or am I just crazy to be thinking about this?
The other question is if I install a second tap or make the hard water connection outside to the current tap (rather than fiddling about under the sink unit) then there would be about 5ft of copper pipe on the wall outside. Is that a freezing hazard? Even if Iag it? Should I put an iso valve inside the house and have to drain it before winter?
thanks again.
have moved recently into new house (London hard water area) and want to install a second garden bib tap to serve the front garden. No issue there can take a run of pipe within the garage to the front.
Ive noticed though the tap at the back garden is run off the water supply in the utility room. All of the house water supply comes via a BWT salt water softener unit. So basically I am watering the back garden with soft water and wasting my salt.
I can run a new line to the back from the garage to the wall in the utility room and connect the back garden tap to the hard water supply in the garage (ie before the water softener unit).
To connect to the bin tap union connection within the utility room is a bit (a lot) fiddly as the current pipe comes into a sink unit. Can be done but I’d have to remove the current wallplate flanged pipe and replace with a straight pipe and a wall plate elbow outside to be able to pull the pipe in make the connection inside and then push the pipe out.
But one thing we do from time to time is fill the hot tub (1500 litres) and think this might be better to do with soft water so what I was thinking is maybe introduce a T with two isolation valves one from the current soft water line and one from a new hard water line.
is that allowed? Is there a better way to do this? Or should I just leave the current set up and put in a second bib tap at the back so the two lines don’t mix? Or am I just crazy to be thinking about this?
The other question is if I install a second tap or make the hard water connection outside to the current tap (rather than fiddling about under the sink unit) then there would be about 5ft of copper pipe on the wall outside. Is that a freezing hazard? Even if Iag it? Should I put an iso valve inside the house and have to drain it before winter?
thanks again.