Thorn Olympic issues | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Thorn Olympic issues in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.

armyash

Esteemed
Plumber
Gas Engineer
Subscribed
Messages
2,650
Hi

I was called out to this boiler a few days ago. As soon as boiler came on all the power tripped in the house.

Unwired the 3port and was ok. Replaced 3 port, turns out pump had seized also.

Replaced pump. As the power was initially tripping I was unable to test anything else.

Now, ch and hw will circulate ok but hw is getting too hot cust says and they turned it all off and now won't come back on.

I can hear air in the pipes in the airing cupboard.
They have all rads upstairs turned off except bathroom.

System was fitted in 1978, custs in 80s doesn't want to be spending thousands out.
 
Last edited:
The 3 port will put live onto Boiler and pump so by disconnecting the 3 port you disconnected the pump by the sounds of it?

If the water is now too hot and wasn't before, Check the Cylinder stat and associated wiring.

Did you not test the 3 port before you swapped it?
 
Last edited:
The 3 port will put live onto Boiler and pump so by disconnecting the 3 port you disconnected the pump by the sounds of it?

If the water is now too hot and wasn't before, Check the Cylinder stat and associated wiring.

Did you not test the 3 port before you swapped it?

I couldnt test as the valve body was leaking in to the actuator, tripped everything the second a demand was put on.

Will take a cylinder stat with me tomorrow when I check the wiring. Will take a new three port just in case this new one is faulty.

View attachment DSC_0469.JPG

View attachment DSC_0470.JPG
 
Change those disgraceful quarter turn valves whilst you're at it.

I don't like the set up there.

What's above it pipe work wise?
 
There is a 22mm fitting above thist It's a cross ➕ fitting but no pic. I think this may causing a restriction but have drained and filled OK.

When ch working it's fine but then getting really hot at pipes and pump in airing cupboard.
 
Will check temps in the morning.

3port has been changed. I had to change that before I could do anything else.
 
Status
Not open for further replies.

Similar plumbing topics

Good idea, as that rad will keep the feel (if...
Replies
4
Views
709
  • Question
OK thanks for the response. I hadn't...
Replies
5
Views
837
Replies
0
Views
505
Several people told me it would be an Airlock...
Replies
4
Views
752
All sorted now and running better than ever...
Replies
3
Views
1K
Back
Top