- Messages
- 59
Hi all,
2 things if that's ok?
Firstly what do most people use to tighten the connectors on a vented cylinder? the insulation is so thick the connector is in a tunnel of approx 1 1/2 - 2 inches deep so impossible to get a spanner in there without removing loads of insulation? I may have to drain the cylinder again as I have a weeping connector, I thought about using a socket on the connector but obviously now there is a pipe connected I can't.
Secondly the joint was leaking to a point that it soaked a hand towel I left underneath it overnight for me to continue this morning but it looks like the leak has stopped? I used Thernox Jointing compound could this have warmed and sealed overnight or am I being too hopeful!
2 things if that's ok?
Firstly what do most people use to tighten the connectors on a vented cylinder? the insulation is so thick the connector is in a tunnel of approx 1 1/2 - 2 inches deep so impossible to get a spanner in there without removing loads of insulation? I may have to drain the cylinder again as I have a weeping connector, I thought about using a socket on the connector but obviously now there is a pipe connected I can't.
Secondly the joint was leaking to a point that it soaked a hand towel I left underneath it overnight for me to continue this morning but it looks like the leak has stopped? I used Thernox Jointing compound could this have warmed and sealed overnight or am I being too hopeful!