todays nightmare,post the most difficult appliances to work on

[Billy Bob Bob]

i do service work for bfm europe,had this one today as repair,all this to change a pcb,and the glass is a pig to get back in took 2 hours and i have worked on loads,log assembly and glass removed for clarity ATTACH=CONFIG]25633[/ATTACH]

 

[lame plumber]

rather you than me

 

[Dotty]

I posted ages ago about trying to trace a fault on an MHS Ultramax. Couldn't trace a fault without power on, couldn't put the power on because the fault blew £800 worth of control module.......

Gnnnnnnnnnnnnnn..........

 

[Billy Bob Bob]

rather you than me

the worse thing is ,while i was there replacing the pcb for a detection fault,customer mentioned the cooling fan runs constantly,the high limit stat on its failed and bfm have not issued any as van stock,so i have to go back and do all that again,but only if they issue another job number to pay me again,and its got a seven year warrenty,so i might be back a few times :cry_smile:

 

[Billy Bob Bob]

I posted ages ago about trying to trace a fault on an MHS Ultramax. Couldn't trace a fault without power on, couldn't put the power on because the fault blew £800 worth of control module.......

Gnnnnnnnnnnnnnn..........

i remember that one,did you sort it?these fires are crap,this one cost 1700 quid ffs

 

[Atouchofgas]

Sounds a nightmare, almost as bad as an Gazco Electric studio. Took me the same length as time as you did

 

[Dotty]

i remember that one,did you sort it?these fires are crap,this one cost 1700 quid ffs

I ended up taking a punt on the fan...........

 

[lame plumber]

I ended up taking a punt on the fan...........

was that some sexual perversion?

 

[Dotty]

was that some sexual perversion?

Only in Ilfracombe. ....