toilet installation, iron soil pipe connection | Boilers | Plumbers Forums
  • Welcome to PlumbersTalk.net

    Welcome to Plumbers' Talk | The new domain for UKPF / Plumbers Forums. Login with your existing details they should all work fine. Please checkout the PT Updates Forum

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

American Visitor?

Hey friend, we're detecting that you're an American visitor and want to thank you for coming to PlumbersTalk.net - Here is a link to the American Plumbing Forum. Though if you post in any other forum from your computer / phone it'll be marked with a little american flag so that other users can help from your neck of the woods. We hope this helps. And thanks once again.

Discuss toilet installation, iron soil pipe connection in the Boilers area at Plumbers Forums

Status
Not open for further replies.
L

laike

hi, i wanted to install a toilet in my shower room. there has never been a toilet connected to this waste pipe before.

could i connect a toilet soil pipe to this shower waste pipe? it all goes to the sewer, right? there's not dedicated pipes for water waste and others for toilet waste, is there?

IMG_4802.jpg
 
you may have an issue when you try sending 6 liters of water half a loo roll and a big old Richard down an inch and a half pipe
 
if you can access the soil stack bellow i would advise changing it all to plastic if you cant then change from the lowest point you can access all the way up. but make sure it is all the way up its never a good idea to leave 4 meters of cast iron stack sitting on a bit of plastic.

ultimately yes it can be achieved one way or another if there really was no other way then a macerator will do it. but that would be my last resort
 
I agree. If you own the entire stack, or from that level upwards, then change to plastic if you are brave enough to attempt it & if you can get near it. I wouldn't want a macerator either & would prefer to do days of work if necessary to install new stack, but it would also sort your problem.
 
Last edited:
That looks like a pan inlet on the right of the stack. You could just use that to connect, in the same way as the 42mm pipe is connected in the picture. This will work unless (a) it's a 3" inlet or (b) you want the pan on the same wall as the 42mm pipe. If either of the afore mentioned is the case then it's going to be one of the other suggestions I'm afraid. Personally, I'd replace the stack :)
 
Use the white pipe and keep some drain rods by the new toilet to rod it through each time you use it! :toilet:
 
Status
Not open for further replies.

Similar plumbing topics

Thanks Shaun and Last Plumber. I checked the...
Replies
3
Views
451
10 o’clock / 45 degrees would be better than...
Replies
3
Views
609
Sorry for the late post on this but just...
Replies
23
Views
2K
Thanks yes I've seen that but it doesn't give...
Replies
2
Views
5K
Back
Top