Novice here so please bear with
Have a Triton Thames Dual Control and there have been no problems . The control/flow knob came off in hand and so I tried pushing it back into the spindle and it just won’t go back in properly and waggles around. I am not a total idiot and cannot see why this is case. The attached section from the manual mentions securing with a grub screw but I can’t see where that would be. Ultimately I can’t get the control/flow knob to secure and don’t know why. Please take a look at the photos attached and see if there is anything you can recommend. I am sure it is user error . Thanks in advance
Steve
Have a Triton Thames Dual Control and there have been no problems . The control/flow knob came off in hand and so I tried pushing it back into the spindle and it just won’t go back in properly and waggles around. I am not a total idiot and cannot see why this is case. The attached section from the manual mentions securing with a grub screw but I can’t see where that would be. Ultimately I can’t get the control/flow knob to secure and don’t know why. Please take a look at the photos attached and see if there is anything you can recommend. I am sure it is user error . Thanks in advance
Steve