Type 10 rad to type 22 - pipes don’t match

[Rosie55]

I’ve just replaced my radiator, from an old 104cm type 10 to a new 100cm type 22.
On one side the pipes connect to the valve fine.
The other side - the radiator is around an inch from the wall and pipe.

How do I connect the valve to the inlet?
I cannot move the pipe as it comes from a concrete floor with suspicious tiles covering (covered by underlay and carpet). So I’d rather not dig around too much.

Any help appreciated

 

[ShaunCorbs]

Have to drain down and adjust the pipework to match eg make a set or two elbow etc

 

[Deleted member 120897]

It’ll be a type 11 not 10, but that’s irrelevant. A photo would help, but you’re going to need an offset or elbows as Shaun said.