R
roche1800
Hi, please can some one point me in the right direction.
The property is around 6 years old and I believe all the zones have been working.
The house has a manifold (near the boiler) in the basement, with a secondary manifold on the ground floor with rads upstairs.
The basement manifold feeds 7 zones.
The end zone flow does not get warm, despite turning all the other zones on the manifold off. So back to the stat, it is the non digital type, I can hear it click at say two thirds round. I crank it to full and nothing happens.
I have removed the actuator in an attempt to simply allow the flow of warm water around the zone, nothing happens.
I can push the "plunger" (below the actuator) and feel it physically move.
Again I have this problem off the secondary manifold.
Any pointers or tips from anyone.
The property is around 6 years old and I believe all the zones have been working.
The house has a manifold (near the boiler) in the basement, with a secondary manifold on the ground floor with rads upstairs.
The basement manifold feeds 7 zones.
The end zone flow does not get warm, despite turning all the other zones on the manifold off. So back to the stat, it is the non digital type, I can hear it click at say two thirds round. I crank it to full and nothing happens.
I have removed the actuator in an attempt to simply allow the flow of warm water around the zone, nothing happens.
I can push the "plunger" (below the actuator) and feel it physically move.
Again I have this problem off the secondary manifold.
Any pointers or tips from anyone.