Underground drainage problem i have to deal with | Ground Sourced Heat Pumps | Plumbers Forums
  • Welcome to PlumbersTalk.net

    Welcome to Plumbers' Talk | The new domain for UKPF / Plumbers Forums. Login with your existing details they should all work fine. Please checkout the PT Updates Forum

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

American Visitor?

Hey friend, we're detecting that you're an American visitor and want to thank you for coming to PlumbersTalk.net - Here is a link to the American Plumbing Forum. Though if you post in any other forum from your computer / phone it'll be marked with a little american flag so that other users can help from your neck of the woods. We hope this helps. And thanks once again.

  • Thread starter julesverne
  • Start date
  • Replies 9
  • Views 798

Discuss Underground drainage problem i have to deal with in the Ground Sourced Heat Pumps area at Plumbers Forums

Status
Not open for further replies.
J

julesverne

I wouldnt normally do drainage of this type but its a big company i do work for so dont want to pass it on to

Water leaking up through a concrete floor in part of the factory they know their waste water its all coloured water form the water based ink waste they pour down. So my plan is to dig down to the clay drain assuming it is clay. Cut it out and connect a new a new piece. Can someone suggest the best way to connect a new piece of drain.

thanks in advance
 
As long as you have room, a good clean square cut either side of fracture/bad joint
Short piece of underground 4" connected with a rubber slip coupler either end
Don't remember the name of the connectors, but they have stainless jubilee clips on either side giving you a bit of leeway with the size
Plenty of sizes to chose from

ww.ebay.co.uk/bhp/rubber-coupling
This sort of thing

http://www.polypipe.com/building-pr...ge/flexicon-flexible-rubber-couplers-adaptors
First link didn't work try this
RPM got closer than me with the name
 
Last edited:
I`m thinking Flexcon or Fenox coupler or is that only for smaller pipes?
 
Last edited:
Think I may have seen these larger rubber couplers in Wickes.
 
Toolstation stock couplers in standard sizes, for a greater range you might have to use a plumbers merchant. Find and measure pipe before buying coupling, some old salt glazed pipe is much larger than supersleeve.
Backfill with shingle surround to limit settlement and protect pipes from further damage.
 
If its old earthenware/clay, dig out all around and below, mark where you want to make your two cuts to add in new section of pipe, cut in twice half way down once where you want to cut and once 4-6 inches in then remove top section of pipe so you can get grinder in and cut all the way through

Then just two jubilee connectors and some pipe
 
Williams do them
[DLMURL="http://www.tradeonlyplumbing.co.uk/miscellaneous/flexible-couplers.html"]Flexible Couplers - Miscellaneous | Trade Only Plumbing & Heating Supplies[/DLMURL]
 
Last edited by a moderator:
Status
Not open for further replies.

Similar plumbing topics

Many thanks for the helpful replies. There's...
Replies
4
Views
1K
  • Question
First, ensure the exact position of the leak...
Replies
7
Views
2K
G
Need to remove the boxing could be a bad boss...
Replies
1
Views
2K
  • Question
Well I am clearly not a plumber LMAO so that's...
Replies
4
Views
1K
Is the gas pipe magnetic?
Replies
3
Views
3K
Back
Top