Vaillant ecotec 837 hot water problems | Bathroom Advice | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Vaillant ecotec 837 hot water problems in the Bathroom Advice area at Plumbers Forums

A

Aire

Hi guys, currently at the above boiler with no hot water. Plate gets hot so preheat is working but when I open a hot tap nothing happens, no tap symbol or anything.

The customer did say that when they was having some ground works done and the mains was accidentally cut and a fair bit of sand and much got flushed into the system and hot water hasn't worked since.

Any ideas?
 
Flow switch ?

If you get no tap symbol it’s not sending the flow
 
Managed to get a signal and ran though it with technical and they reccomended flow sensor. Which when you think about it makes sense, Shaun said, no tap symbol so it's not picking up demand is required.

I really need to get myself on a few installer courses, I did strip the flow sensor initially and tried to clean it but then spent another 2 hours stripping the diverter and cleaning the plate just in case any muck was causing an issue :oops:

Anyway I've got a new flow sensor coming tomorrow so hopefully that cures it.
 

Similar plumbing topics

C
  • Question
Thanks for replying matey. You've been a...
Replies
3
Views
1K
  • Question
£330 And tbh finding a good service engineer...
Replies
5
Views
822
Could be the thermostat/external controls...
Replies
1
Views
92
Deleted member 120897
D
  • Question
Could be the washer in the tap itself.
Replies
1
Views
690
If you have a hot tap or taps, set your DHW...
Replies
3
Views
1K
Back
Top