Vokera Linea 01 fault

[jefaz]

Morning boys,hope you are all well,
move been called to a 01 fault on the above boiler and I'm going later on.
Question is do any of you have experience with this fault? or any common faults? I don't do many of these to any help appreciated.
Jefaz xx

 

[Atouchofgas]

Common fault in these are flue Venturi chokes, needs stripped and cleaned. Check bp esp low flame

 

[jefaz]

Cheers touch,will do!!

 

[neily01]

Had one ignite briefly then shut down, the ignition lead had no continuity but the spark was strong enough to jump the gap and not sense the flame.

 

[diamondgas]

Card meter? 01 is flame detection far as memory serve's me jefaz ... so fan's been detected but flame hasn't .. gas valve/gas/flame sort of approach yeh?

 

[jefaz]

Been to have a look diamond....sparking but no ignition.
Gas supply's are fine so was looking at gas valve or ignition board,didn't know the values I should be getting on my multimeter so gonna ring vokera tech in the morning

 

[diamondgas]

Maybe test for expected ignition BP and correct power to valve... Without looking at MI's I wouldn't know what they were, to be honest If you have a spark and no flame I'd be me more concentrating on the valve or its power supply!

 

[jefaz]

Cheers diamond,top notch as usual

 

[tamz]

The gas valve is 230v. If no power at the valve it needs an ignition board.

 

[vern]

The gas valve is 230v. If no power at the valve it needs an ignition board.

Yeah and there is 3 different sorts, early type blue sit box attached direct to gas valve, later one is a little board on the right of main PCB covered in black compound, later still the same with different pins get the boiler GC No and serial if its a little black board

 

[mfgs]

Good luck with vokera tech haha, they are real stroppy *******s.

 

[jefaz]

It's the blue board attached to the gas valve.