Vokera linea 28 problems | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Vokera linea 28 problems in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.

Hobo128

Gas Engineer
Messages
292
Im trying to diagnose this boiler, when i run the hot water the boiler is banging and then locking out, fault code 02. After a minute i can reset it. Also the pressure needle starts fluctuating rapidly when hot water is run. Ive taken out the plate and cleaned it out which seems clean, it doesnt seem to do this when c/h demand. I have a feeling it the pump but not sure. Any ideas? Also, this is my own boiler and i do have a new worcester waiting to be fitted but im flat out at work and have no time, shocking.
 
Isn’t 02 on a Vokera overheat. Check the basics first. Pump/main heat ex/pressure/airlock/vessel. Is it kettleing?? Try lowering the temp in the boiler. To see if it still does it. But does normally mean a circulation problem
 
Diverter could also be at fault. Start with the above advice though.
 
Status
Not open for further replies.

Similar plumbing topics

This response doesn't make any sense, as the...
Replies
23
Views
2K
Easy done when you start bud, post around 10...
Replies
8
Views
2K
S
Yes I gathered you meant that cover, but it...
Replies
6
Views
1K
Deleted member 120897
D
  • Locked
Linea flow rate 14.2 outputs on new combi...
Replies
1
Views
1K
All sorted now and running better than ever...
Replies
3
Views
1K
Back
Top