I have two Zanussi washing machines, one is a 2006 model ZWF1221G, the other, a 2013 model ZWG6141P.
I can run both from the CWST or the mains, recently was doing a bit of pipe re routing and noted the following.
On the older machine if the water supply is changed from the CWST to mains then the fill time falls from 259 secs to 114 secs as expected due to the increase in water pressure but on the newer machine the fill time of 120 secs is exactly the same on either CWST or mains fill which seems very strange as I thought that the pre determined drum fill level is monitored by a pressure switch as is apparently the case with the older machine.
If the water supplies are turned off before start up, both machines will go into alarm (flashing run light) after 5 minutes.
I can run both from the CWST or the mains, recently was doing a bit of pipe re routing and noted the following.
On the older machine if the water supply is changed from the CWST to mains then the fill time falls from 259 secs to 114 secs as expected due to the increase in water pressure but on the newer machine the fill time of 120 secs is exactly the same on either CWST or mains fill which seems very strange as I thought that the pre determined drum fill level is monitored by a pressure switch as is apparently the case with the older machine.
If the water supplies are turned off before start up, both machines will go into alarm (flashing run light) after 5 minutes.