Washing machine hose connector not screwing on fully

[Numanaly]

Hi! Sorry we are first time buyers! So May be a stupid question! The water hose for our new washing machine doesn’t fit the water inlet? (Photos attached). It screws on but not all the way, and if I open the valve it sprays water everywhere. Do I need a connector or something? Any help/advice would be greatly appreciated!

 

[Timmy D]

They look like standard appliance valves, with an adapter screwed on (black bit).

If you add a pic showing the back of the adapter/opposite end of the valve to the 15mm compression, we should be able to confirm. Or just get a spanner/grips and remove the black adapter and the hose should connect correctly.

 

[Numanaly]

They look like standard appliance valves, with an adapter screwed on (black bit).

If you add a pic showing the back of the adapter/opposite end of the valve to the 15mm compression, we should be able to confirm. Or just get a spanner/grips and remove the black adapter and the hose should connect correctly.

Hi Timmy,

does this help??

 

[ShaunCorbs]

Remove the black adapter

 

[Numanaly]

Remove the black adapter

Sorry if it’s a stupid question, but do both these come off? Or is it just one piece? And is there a threaded section under the black threaded section?

 

[ShaunCorbs]

it should undo off the silver valve

One piece

yes the valve is threaded to accept the machine hose

 

[Timmy D]

Hi Timmy,

does this help??View attachment 62048

They do, as Shaun replied, remove the adapter 👍🏼

 

[Numanaly]

Thanks a lot!! It worked! I really appreciate this! Thanks

 

[Timmy D]

Thanks a lot!! It worked! I really appreciate this! Thanks

Thanks for the update. The silver valve thread will not need any ptfe tape, the washer makes the seal, so don’t be tempted. 👍🏻

 

[Numanaly]

Thanks for that! Tested the valve open, runs perfectly!