Think I know the answer is no but asking just in case. I have a solvent weld bathroom waste with lots of connectors in it that disappears into the wall with a right angle connector. There is no place to break into it to connect up a new arrangement for a new sink. So does anyone make a connector - solvent or push fit - that has a pipe socket at one end and at the other goes INSIDE the existing pipe? If it does I can simple cut off the right angle connector at the wall and push the new connector into the stub. If not its a pain as the other end comes out the wall behind an old cast iron soil pipe which would have to come off to access it or else a new hole through a 500mm thick wall.
Thanks.
Thanks.