.....Whose dopey.....

[ShaunCorbs]

missed soldering a side oppps

 

[mfgs]

I'm sure we have all done it at some point.

 

[rpm]

Too much crimping made you forget basics?

 

[townfanjon]

Thats nothing I have done far worse, in the middle of fitting a kitchen waste , old dear struggles to get past all my gear to tip a bowl full of dirty water outside , me being a gent takes it off her and tips it straight down the sink . *******

 

[ShaunCorbs]

Thats nothing I have done far worse, in the middle of fitting a kitchen waste , old dear struggles to get past all my gear to tip a bowl full of dirty water outside , me being a gent takes it off her and tips it straight down the sink . *******

I've done that always put a bucket underneath now

 

[ShaunCorbs]

Too much crimping made you forget basics?

Maybe

 

[Ric2013]

The time when you check every joint and then completely forget to solder one of them altogether. Yep, been there. Still, easier to remedy an unsoldered joint than a half-soldered one.

 

[king of pipes]

We have all been there mate hope it all worked out for you

 

[ShaunCorbs]

We have all been there mate hope it all worked out for you

Yep condy and wiring tomorrow

 

[ShaunCorbs]

Anyone seen an old balanced flue with a lintel above it supporting the b block ?

 

[Harvest Fields]

Anyone seen an old balanced flue with a lintel above it supporting the b block ?

Nope. But why are you fitting a Worcester.

 

[Jim Goodenough]

Anyone seen an old balanced flue with a lintel above it supporting the b block ?

Yep, I see it. I like the plywood back board.

 

[ShaunCorbs]

Nope. But why are you fitting a Worcester.

Cus picked it out of 3 baxi Worcester Viessmann

 

[ShaunCorbs]

Yep, I see it. I like the plywood back board.

Was a pain as couldn't lift the boiler where I wanted it only needed around 3" but I'm not coreing through one

 

[Jim Goodenough]

Was a pain as couldn't lift the boiler where I wanted it only needed around 3" but I'm not coreing through one

No exactly, the house might collapse in a heap if you did

 

[ShaunCorbs]

No exactly, the house might collapse in a heap if you did

yep dont know what if anything its supporting, someone might sit on the toilet and end up in the kitchen

 

[Jim Goodenough]

I'm sure we have all done it at some point.

Had one a few months ago, heard this ominous hissing sound! Said to my son, "hear that I'm sure I've got a pin-hole in an end-feed ". Twas easily drained and sweated up properly, but hey-ho I say if you don't get some sort of leak no-and-again you're not a REAL plumber

 

[ShaunCorbs]

Had one a few months ago, heard this ominous hissing sound! Said to my son, "hear that I'm sure I've got a pin-hole in an end-feed ". Twas easily drained and sweated up properly, but hey-ho I say if you don't get some sort of leak no-and-again your not a REAL plumber

to true and its how you deal with them

 

[Jim Goodenough]

yep dont know what if anything its supporting, someone might sit on the toilet and end up in the kitchen

That's called "mega-sore-bum"

 

[Harvest Fields]

That's called "mega-sore-bum"

Or Paine-in-da-arzzzz

 

[ShaunCorbs]

sorry but jim wins only because ive watched jurassic world

 

[Jim Goodenough]

On another note I've often cringed at the thought of someone sitting on a pan with no seat, and it disintegrating into shards of 'mega' sharp shards of vitreous china...... ouch, what a bloodbath

 

[Harvest Fields]

On another note I've often cringed at the thought of someone sitting on a pan with no seat, and it disintegrating into shards of 'mega' sharp shards of vitreous china.... ouch, what a bloodbath

Do you watch a lot of gruesome films mate. Like SAW?

 

[ShaunCorbs]

On another note I've often cringed at the thought of someone sitting on a pan with no seat, and it disintegrating into shards of 'mega' sharp shards of vitreous china.... ouch, what a bloodbath

That actually has happened let's say a new person comes into the uk it's common practice in there country to stand on the rim and do there business

Ended up cracking the toilet and you know how sharp it is didn't end well

 

[Jim Goodenough]

Do you watch a lot of gruesome films mate. Like SAW?

I don't Harvest, but the amount of times I've stood on a pan to get access to drill a hole or solder high level pipework or whatever is unreal! (at the the back of your mind you think what on earth if this falls apart - they'll be a ruddy mess).
You say firmly to yourself 'I MUST NOT DO THAT AGAIN'!