Hello, I've previously had an issue with my boiler pressure getting too high with the central heating on and needing a reset. I had a gas plumber come round and he swapped the expansion vessel. The pressure issue seems to be fixed but now there is another issue...
When I turn the central heating on, the radiators will start to warm up but the boiler will crash/need reset. This happens at random times after I turn the CH on, it could crash after 10 minutes or 30 mins ... or over an hour. The pressure always seems okay - 1.5 to 2.
If I only use the hot water then I have no problems. It's a Worcester combi boiler
The gas man had a look over the connections again and said the next step is replacing the nodes?... and then PCB and Gas valve. This could end up costing a lot. Any advice on how I should proceed?
The error code is a consistent blink, an even on/off rhythm.. I was told this is an ignition error...
Many thanks
When I turn the central heating on, the radiators will start to warm up but the boiler will crash/need reset. This happens at random times after I turn the CH on, it could crash after 10 minutes or 30 mins ... or over an hour. The pressure always seems okay - 1.5 to 2.
If I only use the hot water then I have no problems. It's a Worcester combi boiler
The gas man had a look over the connections again and said the next step is replacing the nodes?... and then PCB and Gas valve. This could end up costing a lot. Any advice on how I should proceed?
The error code is a consistent blink, an even on/off rhythm.. I was told this is an ignition error...
Many thanks