Zoning my

[Dom bell]

I am looking some information on zoning my house the set up I have now is funny one But I have two pumps that pumps water to the rad and too hot tank. When I switch my boiler to hw the pump is wire to the bolier but it heats four rad downstairs when I want just hot water. My other pump witch has a switch on the counter heat one rad downstairs and there a second switch that turn on a valve to send heat upstairs. So I want to zone then to a nest but I don't want heat hot water every time I turn on the heating. Aslo in my bathroom there is a stud wall that is build of a block wall and I think that has the pipes going up to the hot tank as the tank is above it and to my rad because been a while from I was in an building of a house but there is a place were the pipes meet each other

 

[ShaunCorbs]

Sounds like you need to s plan the system eg two 2 ports

 

[Dom bell]

Sounds like you need to s plan the system eg two 2 ports

Thanks for the reply the lay out is mess up so I need to get where all the pipes are at and see if I can change the setup as have all the downstairs rads on one line as the way with upstairs and hot water on its own line aswell would that upset the system. We have a firebird super q boiler yeah it's old. But will wait to it has enough then change

 

[Dom bell]

Here is the layout at the boiler