Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
Questions and plumbing advice in the Showers and Wetrooms Advice - Whether a tiled sealed shower using a tray former and tanking, to create a wet-room. Or even just plumbing in an electric shower or shower using jets or mixer taps. Ask a plumbing question in here..
Normal Threads
Hi i have a triton mimosa mixer shower in my bathroom.
It's combined with the bath and pipes...
I am after a Shower pump to run 1 mixer shower and 1 bath/shower mixer but not sure which to...
customer has picked the following shower door from lakes bathrooms.
Semi-Frameless Pivot Door ...
Hi all.
I have a leaking mixer shower at home. After some research i probably need to replace...
Just found this site & hope you guys can help. I am a competent DIYer.
I've got a problem at...
Hello Dear Plumbers,
Here's my problem:
I use a Vokera Flowmaster Gas multipoint at mains...
Hi everybody, I am new here and my first question is about a little problem I have had in the...
Hi our shower pump is on it's last legs its a salamander RSP50, thought i had found a good...
Hi,
I have a mira event shower (1999).
The other night all of a sudden the electric in the...
have triton combi HP shower valve , water not very hot coming through now,
has this valve got...
Hi folks, I was at a new job earlier at a small nursing home for a first time visit to fix a...
Hi, our shower pump is acting up. Is very noisy when operating and often gets stuck on. The pump...
Hi
We have an AJ Gummer shower 1861 Sirrus - that is dripping very badly from the head and the...
I am purchasing a hand shower on a rail
and have a choice for the wall outlet -
this can...
Hi, I am new to this forum and was wondering if anyone has a solution to a problem that is...
Hi, I am new to this Forum, not a plumber but would appreciate some technical advice. Got a Mira...
Hello all, and thanks in advancefor reading and offering any help. I purchased a Hudson Reed...
Hello,
Does anyone recognise this shower/bath mixer tap?? I need to replace the middle...
The water pressure coming into my house seems too high for my electric shower. I have an...
Hi all,
I am new to the forum and am wondering if anyone would be able to give me a bit of...
Just wondering if anyone has any experience of Byretech and/or their stainless steel shower...
Hi all,
I am putting in a shower mixer valve which is wall housed and it has a rain head and...
Hello,
A plumber recently converted our bath tap into a shower mixer. The plumber advised me...
Hi. I'm installing a new shower. Bottom left with rear entry. I have 10mm pipe coming from tiled...
hi guys, can anyone help, my booster pump has started leaking (its an old one type 304de, so...
Hi guys
Might be putting in a bath soon that does not have a wall either end, only a wall along...
Hi everyone, I've bought a shower mixer tap and would like to install it but I'm not quite sure...
Fitted this about 18 moths ago and the other week the immersion stat failed (cylinder only...
I think identifying this shower mixer and leaky valve might be impossible, but I thought I'd try...
Installed a bristan cheer 8.5kw as a straight swap for a gainsborough 8.5kw yesterday and it...
New Threads
-
-
Vaillant echTEC Plus 838H over pressurisingHello. Not to long ago I took off a radiator...
- Started by lee2lee
- Replies: 0
-
-
Issue replacing 22mm pipe on central heatingHi all I was hoping to make good this corner...
- Started by kristeva
- Replies: 4
-
-
Inspection chamber leakWould someone be able to advise please. I’ve...- Started by BobThomas
- Replies: 8
-
Aliddin easyfit isolator, Anyone with a bad experience of these?Hi all, thinking of fitting the said isolator...
- Started by Barry
- Replies: 2
-
Ultra compact wall hung toilet frameI'm redoing our 4' x 4' downstairs loo. My...
- Started by UserError
- Replies: 1
-
-
So... Does anyone know what this is??As I said, any ideas what this is for? It was...
- Started by Jonnyfrance
- Replies: 5
-
Potterton Promax 15 HEBeen called out to an issue with a Potterton...
- Started by MethodPH
- Replies: 3
-
Best flush cones for low level cistern connections?Any recommendations other than the usual clear...
- Started by macka09
- Replies: 4
-
-
customer wants boiler in unheated storeroomunheated storeroom, with louvre doors open to...
- Started by Gasinspect
- Replies: 2
-
Seized Filling Loop TapHi, any ideas on how I can get this seized tap...
- Started by fadsarmy
- Replies: 1
-
Non-return rat flap/blocker at drain exitHi folks! I have a question re rat flaps /...
- Started by Johnfella
- Replies: 1
-
Texture metal lined pipe?Hi guys Any of you use the above pipe at all...
- Started by macka09
- Replies: 4
-
Rusted screw removal tool??Hi guys any advice on removing rusted screws...
- Started by macka09
- Replies: 0
-
An Boiler be left on with water tuned off?I have a Worcester Greenstar boiler and would...
- Started by Traveller 47
- Replies: 9
-