Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
Questions and plumbing advice in the UK Plumbers Forums - This is the UK Plumbers Forums. Plumbing threads related to UK rules and regulations. Advice for Plumbers in the United Kingdom. Keep Gas-related advice in the Gas Engineers Forum..
Normal Threads
I have a basin waste and a bath waste that ideally I would like to connect together - to empty...
- Justice League
- 7
- 6K
- Latest:
- Justice League
Evening all,
Basically my question is how deep must a 15mm copper pipe be inserted into a push...
What's the best warm water you use and is there any risks associated with them?
- crisvict7
- 1
- 1K
- Latest:
- Last Plumber
Hello, the house was refurbished over a year ago and now we have Green crystals coming out all...
- Els
- 10
- 8K
- Latest:
- king of pipes
Hello everyone,
I have recently had a leak under the sink and a short investigation I found...
Hi, we are having our driveway replaced and want to take the opportunity to replace the...
- Karmann
- 11
- 3K
- Latest:
- Karmann
I have a 15mm T-junction on a cold water pipe that has a small drip from one of the joints. It...
Hi - we have recently taken away a false basement ceiling and discovered this pipe that
runs...
Hi all,
fairly new to G3 work as recently certified (!). Done a couple of installs from...
Hi,
I have a glowworm systempro programmer installed using climapro rf thermostats
I’m wanting...
Hi All
Hope your all doing good :)
I'm moving our kitchen about, so change all...
OK,
We had central heating fitted 3 years ago, all new boiler and radiators,prior we had no...
Purchased a new Frig at Best Buy. The installer came, and left everything b/c there wasn't a...
- RochelleAnn
- 1
- 1K
- Latest:
- ShaunCorbs
How does one access plumbers arms/cafe (not sure of the differenc, is one a virtual pub?)
- Deleted member 120897
- 9
- 1K
- Latest:
- ShaunCorbs
Hello
I'm struggling to understand this code as I cant find it in the User Manual. The display...
Hello all,
Can anyone suggest a good way of relieving this hot water tap of its backnut? The...
- boilingpoint
- 4
- 6K
- Latest:
- boilingpoint
I have plumbed a 2 bed bungalow, leaving out 1 1/2 wastes under concrete floor for shower and...
Hi, I'm 45years old and looking for a career change. Looking at part time college course from...
- Freddie75
- 3
- 3K
- Latest:
- rpm
Hello
I need some help
We have just had an extension built and a downstairs toilet is to be...
- jonnydj73
- 2
- 2K
- Latest:
- jonnydj73
Morning all. Wondering if you can help.
I'm re-doing my bathroom and thought I'd replace the...
- DIYnovice1
- 15
- 5K
- Latest:
- DIYnovice1
I have an oval bath (which I believe is Ideal Standard) with a 2-piece plastic surround. I am...
Hello all, new to forum.
I’m having venting issues with the toilets sucking traps out of each...
- Inthenickoftime
- 4
- 1K
- Latest:
- CHRISX
Are you ready for the heating season ? At CORGI direct, we are here to support you.
10 ways we...
- CorgiDirect
- 0
- 955
- Latest:
- CorgiDirect
New to the forum and hoping that someone can help with this problem.
I've removed a water...
I am looking for a basin waste and trap. I know the simple plughole and chain wastes are...
We live in a 200+ year old house and - over the past couple of days - a noise has started on a...
Hi All
Looking to replace taps on a cast iron bath, accessing them is near impossible (i even...
- bilabonic
- 11
- 4K
- Latest:
- Ric2013
Hi guys any advice much appreciated. We had a new Baxi 630 combi boiler fitted last July. The...
Does anyone have a preference to use solvent weld or compression fittings for waste pipes?
- Justice League
- 11
- 9K
- Latest:
- Justice League
Hello
After a lot of procrastinating I've decided to go down the Hep2o PEX route for our random...
New Threads
-
Choice of pipe for hot water secondary/recirculating systemWhat plastic based / barrier pipe can you use...
- Started by Failte
- Replies: 0
-
-
Vaillant echTEC Plus 838H over pressurisingHello. Not to long ago I took off a radiator...
- Started by lee2lee
- Replies: 0
-
-
Issue replacing 22mm pipe on central heatingHi all I was hoping to make good this corner...
- Started by kristeva
- Replies: 4
-
-
Inspection chamber leakWould someone be able to advise please. I’ve...- Started by BobThomas
- Replies: 8
-
Aliddin easyfit isolator, Anyone with a bad experience of these?Hi all, thinking of fitting the said isolator...
- Started by Barry
- Replies: 2
-
Ultra compact wall hung toilet frameI'm redoing our 4' x 4' downstairs loo. My...
- Started by UserError
- Replies: 1
-
-
So... Does anyone know what this is??As I said, any ideas what this is for? It was...
- Started by Jonnyfrance
- Replies: 5
-
Potterton Promax 15 HEBeen called out to an issue with a Potterton...
- Started by MethodPH
- Replies: 3
-
Best flush cones for low level cistern connections?Any recommendations other than the usual clear...
- Started by macka09
- Replies: 4
-
-
customer wants boiler in unheated storeroomunheated storeroom, with louvre doors open to...
- Started by Gasinspect
- Replies: 2
-
Seized Filling Loop TapHi, any ideas on how I can get this seized tap...
- Started by fadsarmy
- Replies: 1
-
Non-return rat flap/blocker at drain exitHi folks! I have a question re rat flaps /...
- Started by Johnfella
- Replies: 1
-
Texture metal lined pipe?Hi guys Any of you use the above pipe at all...
- Started by macka09
- Replies: 4
-
Rusted screw removal tool??Hi guys any advice on removing rusted screws...
- Started by macka09
- Replies: 0
-
An Boiler be left on with water tuned off?I have a Worcester Greenstar boiler and would...
- Started by Traveller 47
- Replies: 10