Hello,
I've got this reducer FloPlast Overflow Waste Reducer White 32mm - https://www.NoLinkingToThis/p/floplast-overflow-waste-reducer-white-32mm/99045
I can just about fit the 32mm end into a 32mm metal waste coming from a sink trap (something like this: Brushed Brass Bottle Trap | Basin Trap | Victorian Plumbing - https://www.victorianplumbing.co.uk/arezzo-brushed-brass-round-basin-bottle-trap?campaign=googlebase&gclid=Cj0KCQiAxc6PBhCEARIsAH8Hff1RTpdzUYazIUD7aKqQRfjoIvLMB6DPEBs1GTRdAlB1w22eduT9vngaAimUEALw_wcB&gclsrc=aw.ds)
I want to reduce this waste to 21.5mm where it goes into the wall, hence why I'm doing this. The adaptor says solvent weld or push fit. Obviously I can't solvent weld this to a brass pipe but considering putting a bit of fernox on and then straight into the brass pipe (I haven't dared shove one all the way in there as I'm pretty sure I'd never be able to get it out again it's that tight a fit).
I know it sounds cowboy but anyone have any experience doing this? Metal to PVC is always a pain but standard connectors are out of the question as none of the plastic should be on show.
Thanks
I've got this reducer FloPlast Overflow Waste Reducer White 32mm - https://www.NoLinkingToThis/p/floplast-overflow-waste-reducer-white-32mm/99045
I can just about fit the 32mm end into a 32mm metal waste coming from a sink trap (something like this: Brushed Brass Bottle Trap | Basin Trap | Victorian Plumbing - https://www.victorianplumbing.co.uk/arezzo-brushed-brass-round-basin-bottle-trap?campaign=googlebase&gclid=Cj0KCQiAxc6PBhCEARIsAH8Hff1RTpdzUYazIUD7aKqQRfjoIvLMB6DPEBs1GTRdAlB1w22eduT9vngaAimUEALw_wcB&gclsrc=aw.ds)
I want to reduce this waste to 21.5mm where it goes into the wall, hence why I'm doing this. The adaptor says solvent weld or push fit. Obviously I can't solvent weld this to a brass pipe but considering putting a bit of fernox on and then straight into the brass pipe (I haven't dared shove one all the way in there as I'm pretty sure I'd never be able to get it out again it's that tight a fit).
I know it sounds cowboy but anyone have any experience doing this? Metal to PVC is always a pain but standard connectors are out of the question as none of the plastic should be on show.
Thanks