I need to renew my unvented cert, looking online Worcester Bosch do the course for £100. Which is a lot cheaper than I paid last time.
I know they are all the same but it seems too cheap. Has anyone done the course with Worcester?
I have a Bosch Worcester 24Si II boiler (see picture of control panel below). It's in an external housing outside the kitchen. Last night there was no hot water.
I've followed the instructions in the user manual:
- Initially the fault light was flashing slowly and after resetting it (holding...
Just been to look at a job for some plumbing bits and they mentioned their boiler, said it was just serviced by Worcester Bosch. 42cdi on 22mm pipework.
The engineer mentioned they should change it but signed it off..
Really?????
Hi there - can anyone make a recommendation as to whether I should go with a Worcester Bosch or Baxi system boiler when installing a Megaflo hot water cylinder? This is a full house renovation and the owner wants to use an iBoost (from their new solar PV) with the tank.
Any experiences (good...
MaidenheadChris
Thread
baxi
boiler
bosch
install
system
worcester
worcester bosch
Just had a new customer having a problem with her boiler Worcester 38cdi showing fault code C6 boiler installed 2012 December saying it's out of warranty not a Worcester man myself so any advice would be very helpful before i pop round to have a look.
Hello All
My Boiler is dropping pressure and the hot taps are running lukewarm. Pressure was never great..3 floors up so only ever just over 1 bar. I called out the Gas Safe engineer who usually services the boiler and he said that the flat plate exchanger would most likely be scaled up...
Guys looking for some advice
I have a property that we are working on we have the following
gnd flr
wc
kitchen with dishwasher and one basin
water softener
1st flr
ensuite
shower toilet and basin
ensuite 2
shower basin bath and toilet
2nd flr
shower
basin
toilet
washing machine
We have...
boiler runs at 75c then drops to 45c the buner cuts off and fan goes to low speed as if in condences mode i have change the pcb board and wiring loom high limit stat and primiy stat i think it may be bad pump circulateteison but the pump seems to be runing ok (but may be not) ?
dose any one have...
Anyone know of a co.who can supply and deliver me with Worcester boilers at a good price and high volume (50 a month) indirectly? Don't want to deal with Worcester directly or any plumb centres? All suggestions welcome
I am quoting on a job in a very nice property the problem I have is the boiler will be in a purpose built boiler room just off the utility room downstairs the existing boiler has a mono draught flue and if floor mounted , the cylinder will go in the same place as the existing which is central to...
Hi, I'm new to this forum and the question may have been asked previously, but if it has I can't find anything. My problem is that the boiler seems to always "Lockout" during the night and has to be reset in the morning to fire up. Sometimes it fires up briefly then locks out again. When you...
Hi our worcester 30cdi is causing us much confusion. A while ago the temp in the shower started fluctuating this got worse until the water got very hot, followed by the boiler cutting out, ice cold water, then boiler went from U0-U9 before restarting. Same thing happening at taps. New parts so...
I have a 28i Junior with M10 manual timer.
The boiler has been operating fine and I'v been using the the ON and OFF positions on the M10 timer to switch the heating on and off rather than using the timer.
Yesterday the when i turned the switch to OFF it didn't turn the heating off. The only way...
just sat my re assessment at Worcester bosch £400 instead of £1400 locally and when I found out I could use my Worcester points I asked for a refund and they gave it to me cant say fairer than that before you all rush off to do your re-sits with them we were six"lads" with 200 + years in the...
We have just had our boiler serviced, after about an hour of having the heating on the display shows: -¦¦- and the boiler makes a very load vibrating noise which can be felt when touching the boiler.
Our engineer wasn't sure what could have caused it, he will be back in a few days to take a...
One of my radiators was hot at the bottom, but not the top. I bled it then noticed it went all cold after an hour. I noticed the pressure valve was at 0 so I got that back up to 1.5. Now I have no hot water coming out of any of the taps, none of the radiators are working.
The boiler makes a...