cistern | Page 8

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

cistern

Recent contents Top users
  1. Paul Haynes

    Replacing lid on 2 button cistern - whole mechanism screws out

    Had to take the lid off to replace the inlet diaphram, but now can't replace the lid without also messing up the two button mechanism. This is not a 'normal' two button cistern, where the buttons can be removed individually, with this one (make unknown) the whole dual button bit unscrews so you...
  2. N

    Toilet Cistern Overflowing (Picture Included)

    Quick question please, the toilet cistern is constantly over flowing and I need to adjust the fill valve. Am I right in assuming that the part circled should turn so that it can be adjusted? Or do I just need to bend the ball cock arm? Thanks Phil.
    • Nelder
    • Thread
    • cistern toilet
    • Replies: 24
    • Forum: Boilers
  3. Sleekarleng

    Stumped and doesn't know how to open gph dual push plate cistern

    Hi Everyone! My name is Steph and I have been searching hi and low for knowledge on how to open my cistern. No button plate looks like mine and I'm kinda stuck. Please help me if you recognize it! Thank you!
  4. J

    Help identifying a toilet cistern filler valve?

    Hi I'm a home owner as was going someone here could help me identify my toilet filler valve and where I can source it? Thanks Neil
    • Jarvo273
    • Thread
    • cistern toilet valve
    • Replies: 5
    • Forum: Boilers
  5. J

    Water doesn't fill under cistern lid

    Hey lads, Trying to fix a toilet for a lady friend (to make a good impression, you know) but having a hard time. It doesn't flush, and the only it does is when I use the hose from the shower and fill up the tank with water. Once it gets to a certain point, it flushes okay, but obviously it...
  6. U

    Weeping WC cistern siphon/flush pipe joint repair

    I have a concealed WC cistern. The seal between the cistern tank and siphon has started to weep ever so slightly. Access to the cistern is very difficult. I know the correct thing would be to remove the siphon, clean the seal landings and reassemble. However, to this I would have to get direct...
  7. C

    JAPKAP high level cistern restoration help!

    hello, I’m currently attempting (with very little knowledge) to renovate an old JAPKAP toilet cistern. I’ve so far fixed the wooden box, the lead is fine and flush arm is being re-cast. However I’m really unsure of how to repair the flush pipe (I think that’s what it’s called) as it was...
  8. Bogart

    Leaking bottom inlet on toilet cistern.

    Just fitted a new WC and all okay except I cannot get the bottom water inlet to seal. It is a Fluid master setup. It drips from between the cistern base and the plastic nut not between the nut and the thread. It came with a flat washer, have even tried 2 washers, came with a spare in case...
    • Bogart
    • Thread
    • cistern leaking toilet
    • Replies: 19
    • Forum: Boilers
  9. D

    Concealed Grohe Cistern Leak?

    Hi, looking for some advice regarding my concealed Grohe cistern. Problem 1 - There is a small amount of water appearing around the right hand side at the base of the tiling which houses the cistern and this has been happening for a few months but hasn't worsened. (I initially thought it was...
  10. R

    Upside down cistern fill valve..

    On a job today and asked to change the WC cistern, supplied by customer from a supposedly 'better' online bathroom supplier. The instructions looked a bit suspect as if translated direct from Chinese.. Anyone seen one of these before?? The inlet valve(pictured). No it is not upside down.. The...
  11. R

    Rusted bolts under toilet cistern

    How would you remove seriously rusted toilet cistern bolts? (under cistern) they are beyond help from a spray, the rust has grown. I thought small angle grinder or multi tool.
    • Rob876
    • Thread
    • cistern toilet
    • Replies: 13
    • Forum: Boilers
  12. D

    Help identifying cistern

    Hi all, I recently had new cisterns installed by a builder, who unfortunately turned out to be a cowboy; and has since been kicked off-site. He told us that he’d fitted Geberit; but, I’ve now been informed that they’re most likely a generic Polish model. Anyway, no one seems to be able to...
  13. Bogart

    WC cistern water inlet

    Am trying to fit new WC for daughter. First problem is that the 1/2 inch water inlet hole is a tad too small to fit the fill valve thread. There is a slight lip on the ceramic that needs removing. Tried a half round file gave up with that. Any recommendations as to what to use to remove this...
  14. E

    Geberit Concealed Cistern, Flush very very stiff

    Hi, first post... I have just had installed a UP320 cistern with geberit dual flush plate. When you go to push either button it does not move, like it is very stiff, if you push hard enough it (and you feel like you are going to break it) will suddenly ‘click’ and then work fine. My plumber...
  15. W

    Want to change this concealed cistern

    Will a euro size flush pipe 50mm to 43mm and euro size pan bung likely fit fine in exsiting pan (which i want to keep)? Not seen this flush pipe arrangement before and looks a bit peculiar. Thanks
  16. J

    Cistern overflows to pan when the shower is running.

    The toilet cistern overflows into the pan when the shower on the floor below is running. Why would this be? They say the shower seems low on pressure recently. Again why would this be and what is the connection between the problems if there is one?
  17. J

    Filter restrictor. How do I calculate pressure to the cistern

    Hi. Just about to connect the cistern and came round to fitting the filter restrictor. At first I couldn't push it in to the inlet, however it just needed a little push. Is that normal? More importantly, the instructions state you should cut it down accordingly, depending on the water pressure...
  18. T

    Concealed cistern with pneumatic button issue.

    I am having a slight difficulty with a concealed WC cistern enclosure (I am pretty sure it is a Grohe) which is operated by a pneumatic push-button (no logo). Upon removing the tiled sections that conceal the cistern I am able to get the WC to flush simply by pressing down on the flush-valve...
  19. M

    25mm Gap between the cistern and wall.

    Hi all, just had a new wc fitted and there is a 25mm gap between the cistern and the tiled wall, the only thing holding it all in place are the two screws holding the pan down. Is there any thing I can use to fill the gap and support the cistern? Thanks.
  20. A

    sticking cistern valve

    Based in East Barnet. Several tenants have plumbing problems. Flushing hot water! Some need price for fitting dishwasher. My Problem, posted last week is a sticking valve. Will flush twice then no flow. If I press lever alongside water valve,water fills again. How much would it cost to get it...
Back
Top