Hello,
I have a question. Is it safe to use a light fixture that had water comming through it? There was a water leak comming from a light fixture in my living room around a week ago. The amount of water that came out was about 300-400ml. It wasn't much because i turned off the water in shower...
Got a leaky stopcock/valve/tap as I'm sure many do at this time of year in the northern hemisphere (UK based). Watched a few videos on this common problem, and it seems like some PTFE and an adjustable spanner will do the trick.
Only problem is, my stopcock looks nothing like others; where they...
Hey,
I've got a Grant Vortex that's leaking water from the seal around the expansion vessel - it's the round type about 50cm wide. The system is at 1.5 - 2 bar, but the expansion vessel has no air in it, and it's leaking water. No water is coming out of the Schrader valve either.
The system...
Hi,
We have solar panels for our hot water, so we have the main water tank in the airing cupboard, plus a small pressurised (I think) tank. The smaller one has been leaking for several years leaving rusty water on the outside & on towels in the cupboard. The system also keeps losing pressure...
Hello, as is common with most newbies I've arrived with a problem.
Our water softener is about 18 months old, a BWT WS355 in an insulated outside cabinet.
It's probably the third we've had - been here a very long time and always had a softener.
I installed it myself, just connecting to existing...
Hi, I am after a bit of advice on a leaking mixer tap in the kitchen.
Water is leaking from the area highlighted and varies with the amount of water pressure when using the taps, that might seem obvious, but I am not DIY minded :).
I have removed the mixer and replaced both O rings on the...
Camray 5 (90A) (20 year old) oil boiler, had a noisy fan on the boiler so investigated, just a bit of dirt in the casing however, having removed the burner unit I replaced the Burner Nozzle no problem, old was very dirty and sooty. Found the boiler wouldn't fire up. SO rather than than mess...
I have just tried to balance my heating system (16 cast iron rads, 3 towel rails), all the lockshields were fully open. When I try to close them down, they all leak, from a dribble to a gush. When I say all, I tried 6 and then stopped. The system was installed 9 years ago. Despite extensive...
Hi, I've been having trouble with my boiler leaking for months. We thought we'd fixed it last winter as haven't had any trouble throughout the summer but in the last week or 2 it's leaked again, we had several people out to look at it but no one fixed it. Tonight we've had someone else look and...
Hi
Just fitted a new towel radiator in my en-suit.
Unfortunately it's leaking from the tail piece you screw into the bottom of the rad. I wound round about 4 layers of PTFE tape too. I have since taken it off and wound round 8-9 layers and it screwed up nice and snug but still leaks from both...
Yes, it me again.
I have a leaking compression joint that is connected to plastic pipe. I have now read elsewhere that it is not a good idea to connect plastic into compression joints. It DID have an insert in the plastic pipe.
I decided to use plastic JG speedfit pipe in the compression...
I have a Vaillant ecoFit pure 830 which developed the f.22 fault, the pressure had dropped to 0.2 bar, i refilled the system and away it went, i noticed yesterday that there was water on the floor below the boiler and noticed that water was leaking from a small hole located behind the...
Hi
I fitted a bath/shower 12 years ago and a few months ago it developed a leak.
It was basically at a coupler on 40mm solvent where my new white PVC joined the existing grey PVC.
I cut a hole in the ceiling and could also easily view it with the bath panel off but not access it from there...
I installed a Bristan mixer bar shower about two and-a-half-years ago. I have recently noticed that immediately after the shower has been used, it drips from where temperature control knob turns. I attach a photo. The temperature control is on the right-hand side. The drips last for about...
Hello there.
I wanted to ask more experienced users if there is any possibility of repairing the leaking tap like on the photo.
The apartment is not mine and my landlord hasn't really wanted to fix it for over a year. The plumber sent by him said that he could not repair it and would have to...
Hi all, I have a problem. I have replaced the pan connector from the toilet to the waste pipe however it’s still leaking.
I’ve added plumbers mait which still didn’t fix the leak.
Is it possible to replace JUST the black seal in the 3rd photo attached with purple arrow? I can’t replace the...
I noticed a leak in a toilet in a house I have recently moved into. One of our other toilets is the same but is not leaking from this same "fitting". I gave the leaky one a quick turn to tighten it and it seems to have stopped leaking. Should I have done this, and what is this fitting for...
Heatslave II 25/32 water leak from PHE Inlet block. When DHW PRV fitting was removed a white flat seal/washer was found in 3 pieces. This seal is not listed on any diagram. It sits ahead of the rubber o ring item 45 on drawing and has has the same ID and OD as the oring but is made from white...