mixer | Page 8

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

mixer

Recent contents Top users
  1. E

    URGENT change Kitchen Mixer Tap cartridge

    I do not know how to open the cartridge place. I need to change my Kitchen Mixer Tap Dual Spout with Pull Out Spray cartridge. It is like Rangemaster Aquatrend Spring Kitchen Mixer Tap with Pull Out Spout...
  2. H

    Dripping kitchen mixer tap - problem with pressure?

    We live on a farm and the main water pipe comes down a long driveway and then splits off two ways - 1) to the main farmhouse, which then feeds a pressure washing bay on one of the other units and 2) to the other units, including a small commercial kitchen, and another pressure washing bay. In...
  3. W

    Can't adjust thermostatic shower mixer

    I moved into a property recently and having problems with the shower in the main bathroom. The temperature's always too cold when the dial is turned to the hottest setting. There's scalding hot water getting to the taps and the en-suite shower so I'm assuming the thermostatic shower knob needs...
  4. D

    Boiler HW short cycling due to mixer tap

    Hi. My boiler (a Vaillant Ecotec Plus 8xx) short cycle HW every few seconds and, because of the he priority it means no central heating. If I close the hot water circuit (turning the valve underneath the boiler) then the CH works fine. So, I can either have hot water or central heating. The...
    • Dom_DV
    • Thread
    • boiler mixer mixer tap
    • Replies: 2
    • Forum: Boilers
  5. V

    Franke Eiger mixer tap

    My Franke Eiger mixer tap started leaking from where the spout joins the body. I took the spout off, the o rings looked ok so I put a bit of silicone grease on and put it back. After a couple of days it started again. I have a friend that has about six different boxes of o rings, he must have...
  6. M

    Bristan 3 hole mixer

    Has anyone fitted this type of tap before?
  7. L

    Kitchen mixer tap - how is it fixed?

    We are replacing our kitchen mixer tap, but I haven't figured out how to remove the old one yet as I'm a lowly DIY-er and unfamiliar with the fitting that holds it in place. The old tap is a Franke Zurich, and inspecting underneath the sink I can see it has what looks like a brass tube with a...
  8. M

    3 tap hole basin mixer tap

    Are the tap hole centres on most 3 hole tap centres the same? Have to swap the taps in one that has 200mm centres for the taps with the spout in the middle. Thanks.
  9. elvis80

    New shower mixer - no cold water

    Right, complete amateur alert... I'm fitting a Bristan recessed thermostatic dual control shower mixer. Have fitted two elsewhere in the house without any issues. Got this one all connected and tested the water...hot is fine, nothing from the cold. When I first turned it on there was sound like...
  10. J

    Shower mixer parts advice please

    i have a hidden shower mixer which has been intermittently playing up recently. Sometimes it does not give full pressure and sometimes it does, sometimes it is difficult to turn off as well. Unfortunately there is no manufacturers name visible on the unit anywhere that I can see - I can access...
  11. M

    Bath/Shower mixer

    My wife complained the mixer switching lever was getting stiff so I unscrewed it to see the problem. Something obviously broke in the process as now the mixer is stuck on shower no matter what position the switch is in. To replace the whole unit is around £100. Can spares be obtained for this...
  12. D

    Hydramax (Aqualisa) mixer - thoughts on this?

    Having only really dealt with bar mixers and electric showers this would be a first for me. So my mixer shower started going hot and cold every now and then, and eventually started to leak frequently from the middle, so replaced the cartridge, which has solved the 2 issues. This is the bit...
    • Deleted member 120897
    • Thread
    • mixer
    • Replies: 9
    • Forum: Bathroom Advice
  13. H

    Changing bath mixer tap on Unvented System?

    Good Evening all, hope everyone is well. Im not long out of my time so go gentle please lol. I have the job of replacing bath mixer tap (no isolation valves fitted under bath). It has an unvented cylinder installed. Is it just a case of isolating mains water, opening taps to drain water out of...
  14. T

    Mixer Tap Help!

    Hi All, Brand new to this forum so please be kind! Recently taken in a project to redo my ensuite and have thoroughly enjoyed the process of learning new skills along the way however I'm coming across is bit of a stumbling block with regards to a mixer tap. I decided to bring a main cold...
  15. R

    Kitchen mixer tap disaster - advice please

    I have lived at this house for over 10 years and it has been interesting keeping things working. The latest issue is a weeping kitchen mixer tap. Probably been gently weeping since I moved in but always blamed the slight damp on somthing else. Took it apart and look what I found. Standard tap...
  16. R

    New mixer taps

    Hi there. I'm new to this forum, and just looking for some advice. We have just had a new bathroom and have gone for mixer taps on the bath, but I have noticed that when the hot tap is in the off position the tap lever is not facing straight ahead, it is turning in, and it's gradually turning...
  17. J

    I have a mixer tap on bath, flow on left temperature right but leaking

    I have a shower mixer tap on bath, flow on left temperature right but leaking from temperature control on right side, found a replacement but the flow and temperature reversed, is that ok
  18. P

    Bath mixer shower head height changes temperature

    Situation: Had a boiler system conversion. From Potterton boiler with Gledhill storage tank with on demand hot water to Veissman Combo with on demand hot water. 2 bed semi with only myself and wife living here. Unfortunately used iheat service which has no real customer service. Have had the...
  19. dlawley

    Does anyone know the make of this shower mixer?

    Hi All, we are having issues with this thermostatic shower mixer. There is no brand marking and we are having issues extracting the inlet filters for cleaning. Thanks for any help! We think the filter just needs cleaning but this is turning into a tricky job!
  20. T

    Monobloc kitchen mixer 32mm back nut - spanner

    Anyone coming across these tap fixing components. I'm struggling to find a box spanner to fit. The nut is about 33-34 mm between flats. New install and as far as I can see nothing apart from a box spanner will tighten this. Unless you have the opportunity fit before installing sink.
Back
Top