power

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

power

  1. J

    Power Flushing Central Heating

    Hi, I have an old 3 story property with radiators on each floor. The radiators have become increasingly less efficient so feel flushing the system would have a hopeful benefit. I have bought a secondhand flushing unit (pictures attached) and would like some advice on how to set it up. Also...
  2. liopik

    Vaillant no power. Switches on for few seconds only.

    Hi everyone, I'm hoping to get some advice on an issue I'm having with my Vaillant Ecotec Pro 24 boiler (R1 PCB). It was installed in 2013 and has worked perfectly up until this week. When the boiler does start, it runs for a few seconds, makes some noises, and then shuts down again. I've...
  3. N

    Power Shower Working OK then runs cold.

    We have a pumped shower with a thermostatically controlled mixer valve. My wife complains that when she is having a long shower (hair wash etc) the shower runs at the right temperature for much of the time but suddenly changes to run cold, usually during the hair rinse time, for no apparent...
  4. D

    Do you need a power flush still with new rads

    My Mother-in-law was quoted £1,000 by British Gas to do a power flush on her system as her rads aren't performing well. I was wondering, as 4 radiators need to be upgraded to doubles, would this need to be done if they are drained off and replaced? How does one actually know it needs a power...
  5. A

    Boiler not working after power cut

    Hi all, I have a viessmann vitoden 100 w boiler and we have had a three hour power cut this afternoon/ evening. The boiler switches on and the temp just goes down and then flashes up 0c. From what I can see this error code means blocked burner? The oven also will not ignite. I have tried to...
  6. Gasmk1

    Ideal evomax loses its settings if power turned off

    Does the evomax lose its settings when power turned off
  7. S

    AS2000X stuck in comissioning mode after power cut. PCB replacement?

    Morning All, hoping you can help me out with some advice. I have a triton AS2000x manual power shower, we had a power cut last night after the power was switched back on around 20 minutes later I heard the shower running . It seems to be stuck in comissioning mode. So Ive turned off the power to...
  8. B

    No power to Manifold

    Hi folks, hoping someone can help with a problem that's been perplexing me since just before Christmas..... I have a wet underfloor heating system installed in 2003 and manufactured by Underfloor Direct in NI - Now out of business. It's one of their triple tube systems and hasn't given me much...
  9. R

    Replace Aqualisa power shower to mixer shower

    Hi - I want to replace Aqualisa power shower to mixer shower to a std. mixer shower, however, the centres for the hot and cold are only 65mm. I’ve tried finding something that would be compatible but no joy. Ideal would be a mixer head with the same centres. Does anyone have any idea as to...
  10. E

    Orange spots. Rust. Washing machine or power flush?

    I get orange spots when washing clothes. Please see photo. I think it is rust. I’ve checked there’s no metal in the machine. I have also run a long wash with lemon juice. Neither have solved it. I read power flushing is the answer to rust elsewhere in the system. How can I tell...
  11. Evapourized

    I want to swap my electric shower to a power shower!

    I want to swap my electric shower to a power shower. I have a 200 litre pressurised hot water tank in the loft (not a combi boiler) the hot side has a pump and decent flow, but the cold side/hot side has not got an equal pressure as the cold is just mains fed and would say the flow is below...
  12. C

    What is the difference between a thermostatic and manual power shower?

    Hi, I am not a plumber, I'm a customer looking to replace my existing Mira Go Power (Manual) shower and will hire a plumber to install it. I don't understand technical plumbing terminology. What is the difference between (for instance) the Mira Vigor manual and the Mira Vigor thermostatic...
  13. J

    Pump running but no power to boiler

    On a breakdown which is stumping me. The boiler has no power to it even though everything else in the system is working as it should. The 3 way moves across when it should and kicks in the pump but there is no power on the wire entering the boiler.
  14. M

    Power flush & system corrosion

    In December 2022 (i.e. 5 months ago) I had a full system power flush conducted. Now the previously clear UFH flow gauges are black again. Is it possible that enough internal corrosion could have occurred in this time period? I had a separate plumber out a month ago to test some pipework and he...
  15. C

    Firebird boiler power flush

    Hi i bought the house that Jack built and ohh has the heating been left to spoil. Prior to moving in 2 new firebird boilers were fitted, silver utility 35. The system is in dire need of a power flush and I intend on using FX2 to do the job. Can anyone advise if FX2 is ok with this boiler model ?
  16. J

    Grant Vortex Blue no power to CH pump

    Hi, I have an issue with my Grant Vortex internal combi boiler. Specifically the electrical side. Everything was working fine (with a dual channel Hive system) but then the central hearing stopped working. When looking it seemed like there were a number of loose contacts as when we moved the...
  17. C

    Satchwell 5 2 port power on power off valve.

    Hi first time poster, My elderly Aunts bungalows heating system, Ideal e type cf floor mounted boiler, yes I know it's ancient however she steadfastly refuses to have it changed even when offered a free boiler grant. Long and short her hot water is now getting boiling hot, I suspect its either...
  18. S

    Are my myson power extra valves closing too quickly?

    Hi, we've been having a problem with our motorised valves. Every time the heating turns off there a number of loud bangs as if the water is hitting the valve too quickly which is then sending a shockwave through the pipes. Would this be faulty valves in that they are closing too quickly or is...
  19. S

    does the power switch to the cylinder need to be left on ?

    Hello i have a 300l centre store unvented indirect cylinder. does the power need to be left on for this ? is it left on to keep water at temperature all day ? for a previous system i had a power switch for the immerison heater that was only turned on in an emergency thanks
  20. M

    How to fix power connector to boiler?

    Hey. Got home from Christmas with family to find boiler isn't working, no lights on anywhere. Boiler itself is old but ok. There has been a leak from an upstairs flat and the grey square connector in picture is very wet. Nothing has tripped on main board...I'm guessing either the connector...
Back
Top