replacement | Page 7

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

replacement

Recent contents Top users
  1. Taffy292

    Shower unit Replacement

    Hi all, New here, just taken a shower unit front off defunct en suit. It has hot and cold feed. Can I blank off hot and connect a Triton cara or perloso please. Brother in law had given me a Triton as2000xt, but the manual says not with Combi boiler unless guaranteed flow 14 ltrs (although last...
  2. J

    Grundfos Replacement UPS3 V Alpha 1

    I want to replace the three 11 year old Grundfos UPS 15-60 130 pumps as a part of trying to reduce the electricity consumption of my heating/DHW system. The pumps circulate the water in i) the UFH, ii) the first floor rads and iii) the mains pressure DHW cylinder primary circuit. The Grundfos...
  3. F

    Replacement of cast iron flange

    cast iron top of toilet flange rusted. I removed the top of flange. The top of flange and 4” drain pipe are even and level. Can I replace flange with retro fit pvc/abs flange without removing the remaining part of cast iron flange?
  4. N

    Kitchen waste pipe replacement costs

    Hi, a plumber has been out to my rental property as my tenant reported a blockage causing water to flow back from the washing machine into the dish washer. Both were disconnected and their drainage hoses cleared out but the plumber advises that there is more of a blockage further down the waste...
    • Nadine
    • Thread
    • kitchen pipe replacement waste waste pipe
    • Replies: 3
    • Forum: UK Plumbers Forums
  5. I

    Low cold water pressure after vented boiler replacement

    Hello, I have a had a gravity boiler replaced from a Potterton 80e to a more recent Valliant ecoplus boiler. The cold water tank is in the loft space directly above the 1st floor bathroom and the hot water copper immersion tank is in the 1st floor bathroom cupboard space. A fairly normal...
    • intamixx
    • Thread
    • boiler cold pressure replacement water
    • Replies: 6
    • Forum: Boilers
  6. X

    slow draining toilet following pan connector replacement

    Hello All, We recently had a plumber out to replace a pan connector as the previous set up had developed a leak, however, following the replacement the toilet doesn't drain properly - the flush starts off ok, but partway through the water levels starts to rise, it then takes ages to drain, and...
    • xtsg10
    • Thread
    • replacement toilet
    • Replies: 4
    • Forum: Boilers
  7. P

    Leaking sink waste pipe replacement?

    Hi, the waste pipe under the sink is leaking at the push fit connection. Is there an easy way to seal, or should I replace with a compression fitting? Leak in yellow circle in grey pipe. Thanks
  8. F

    Thermostat replacement

    Boiler is a Worcester Boch Highflow 440 with a TR2 room thermostat. This is an old style bimetal stat and I want to replace it with a digital one, e.g. Honeywell DT90E1012 two wire. Is this going to be possible? I'm assuming that the current three wires are Live, Live Signal and Neutral and...
  9. D

    CH pump replacement concerns.

    Hi. My Parker 15-60 130 pump has been running fine for 7 years at its highest speed. It has recently developed a knocking sound when hot and working hard (disappears on speed 2) but this is not fast enough for my 15 radiator bungalow. Bleeding the pump had no effect so I suspect it might be on...
  10. O

    Vaillant Ecotec 630 plus replacement

    I have a Vaillant Ecotec 630 Plus that was installed in 2007 that is connected to a 300 litre unvented tank. This provides our hot water and feeds 4 floors of underfloor heating. I am looking to replace both the boiler and tank and see they still produce this boiler. I assume the newest models...
  11. Frank15

    Where can I find a replacement bathroom sink (Slough, UK)?

    Where can I find a replacement bathroom sink?, just the sink not the whole closet. My sink broke due to accident and I'd like to replace just the sink, I've checked serveral stores such as B&Q, Victoria Plumbing, and they just sell whole closets with the sink included. I'm in Slough, Berkshire...
  12. A

    Tap replacement issue

    Hi all, Bought this tap adaptor the cold water side works but the hot water side doesn’t seem to want to work. The tap just sits loose whereas the cold side will tighten As I turn the tap handle…Any ideas?
  13. rich1111

    help locating replacement shower mixer

    Hey, I am new to this forum and hope someone could help. I moved into a flat a couple of years ago and the bathroom had been refurbished. Today the handle on the shower mixer broke off and needs replacing. An easy option would be to order the replacement part and fit it but I can't find the...
  14. Mouse 5656

    John Lewis ceramic mixer tap washer replacement

    Hi I have a John Lewis kitchen mixer tap but can’t see the item name just JL. Does anyone know what replacement ceramic washer I’d need? It’s approx 5-7 years old. Many thanks
  15. A

    Replacement shower valve reduced water pressure -need to replace again

    Hi we had a Thermostatic Aqualisa shower valve upstairs that was tank fed upstairs in our house and it had great water pressure. We recently had our shower completely redone and the valve the plumber put in doesn't seem to be very good and the water now has very low pressure. We know the...
  16. N

    replacement model for a Redring Expressions 520TS power shower

    Hi chaps - can anyone recommend a replacement for the above? keeping it as simple as possible please....hot and cold inlets are on tight side as is the cable....cheers Dave
  17. J

    Zone valve - replacement head?

    Hi all, Does anyone know if you can replacement heads for this zone valve? And if so, can you replace the head only (without having to drain the heating pipes)? Thanks Jennie
  18. F

    Keston C55 replacement

    Good afternoon everyone. I'd really appreciate some advice here on a boiler issue. I am being advised to replace my 5 year old Keston C55. I am being told that (a) there is a need for a new heat exchanger (b) that the internal circulator is on its way out and (c) that there is some damp in...
  19. S

    Danfoss RAS-C2 gland replacement - quick question

    Hi guys. Very specific question... Got a RAS-C2 where the pin will only move a fraction of a mil and no amount of the usual tapping/WD40 will help. So looking to change the gland rather than the whole TRV. Has anyone here changed a RAS-C2 gland before? There doesn't seem to be anything to grip...
  20. C

    PVC pipe replacement in ceiling

    This by now way a criticism of our local plumber, who I feel is being open and honest. After a total house drain cleaning he says there is a upstairs blockage in 3 inch pipes leading from two toilets - there’s also sinks, tub/showers in two bathrooms. He was unable to clear these blockages with...
Back
Top