stat | Page 3

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

stat

Recent contents Top users
  1. Robert Bell

    Wireless stat convert to WiFi enabled stat.

    Hi guys. I have a friend with some holiday rentals. They all have a combi in the attic and a wireless RF stat set up. He’s wanting to make them all so he can turn the heating down after the customer has left from his house using the net. Is there a quick solution or will a cable need bringing...
  2. Inverness

    Hive wiring To a room stat

    hi guys, how easy is it to connect a hive to a room stat?
  3. A

    Honeywell stat advice

    Can someone recommend me a simple to use remote thermostat? Preferably a Honeywell. Thanks in advance
  4. M

    Bypassing faulty room stat

    If removing the two wires from the room stat that connect to the boiler to place a link in the room stat terminals in the boiler. As I think a faulty room stat is stopping the boiler from firing. Is it acceptable to leave the link in till I can pop back with a new stat? Bad practice I guess
  5. B

    Cylinder Stat replacement cord

    Howdy Gents Where can I get replacement cord that holds the cylinder stat in place? Many thanks,
  6. N

    Vaillant VRT 340f room stat - error message

    Hi all, I have a Vaillant VRT 340f wireless programmable room stat - the early version without the dial. I've just changed the batteries (2xAAA) - something I've done several times before - and now the display just shows 'Err'. I've tried leaving the batteries out for a few minutes and then...
  7. M

    Wireless stat installation.

    Alright guys. I’m just putting the feelers out ready for tomorrow here folks. I’ve gotta fit a Honeywell wireless stat to a Vokera boiler. I have no experience with either so may need a little help. Cheers guys. Hopefully it’s just a live, neutral and switch live.
  8. M

    Stat wiring advice on a Worcester?

    Hi all. I’m fitting a Worcester 30si tomorrow and it’s having a Nest stat. I’m terrible with wiring so any advice you guys could give me would be great? Cheers
  9. M

    Rf cylinder stat? Has anyone used one are they good?

    I have a job at a b&b that the water is apparently getting scalding. It has an old oil boiler and the hot water is on gravity. I've been out before and the cylinder has been changed not too long ago and has not been installed brilliantly. My only thought is to convert it to fully pumped but...
  10. Ted808

    Potterton H24, goes to lockout after stat turned down

    No paperwork - littl' ol' lady with no idea- She turns the roomstat down at night and then in the morning when she turns it up, boiler doesn't fire, she has to go an reset it, then it works fine again. Fan is a little noisy/ 'gold' pump at boiler end is quite noisy/ gas supply is 22mB...
  11. david stanton

    weather compensator with comfort II stat

    Hi does anyone know if you can fit a worcs weather compensator and it work with the comfort II thermostat, is it just a matter of sighting the weather compensator out side and fitting the wire/ plug to the board and then it "does its thing"?
  12. M

    Glow Worm Ultimate3 Stat Wiring

    Hi, can anyone clarify wiring and Honeywell 927 and BDR91 to a glow work ultimate 3. The BDR91 is currently set up as a 240v feed with 4 core cable. LNE are going straight from the receiver to the boilers LNE. I then have L bridged to A in the receiver. Does B from the receiver just go to RT...
  13. D

    Wiring up a it500 stat

    Im new to this so i was looking for some advice on how to wire up correctly a it500 recevier to a greenstar 30i boiler. I need to wire up for heating and water and i not sure on the correct connections. Any hep woud be appreciated... Thanks....
  14. M

    mechanical timer and wired stat?

    have had a customer on the phone this morning wanting a wired stat adding to an eco elite that's currently controlled of just the mechanical timer, never had this requested before as it's usually a programmable thermostat I'd fit but I can't see how this would work as the switched live is...
  15. T

    High limit stat tripping on a warmflow oil boiler

    Good evening, about 2 years ago a customers high limit stat was tripping every so ofte,n not a sealed system. I turned the circulating pump speed up to 3 from 2 and seemed to cure it , until recently. Tripping again and hes now saying when he turned the Boiler on didn't heat water but rads were...
    • tickdoc
    • Thread
    • boiler high oil boiler stat
    • Replies: 5
    • Forum: Boilers
  16. SJB060685

    Oil boiler flow switch tripping high limit stat

    Can someone explain to me exactly how a faulty flow switch can cause an oil combi to trip a high limit stat?
    • SJB060685
    • Thread
    • boiler flow high oil boiler stat
    • Replies: 3
    • Forum: Boilers
  17. gmartine

    Best wireless room stat + receiver?

    Based on reliability, usability, quality and price.
  18. Scott_D

    Vaillant v-smart stat

    anyone fitting these? @Harvest Fields Are they easy to set up and use? Just quoted an 838 with v-smart
  19. O

    Hot Water Cylinder Stat

    Had a new cylinder stat fitted. Flomasta thing Open vented system, newish boiler, no problems with that or heating now after work done Set at 65 as recommended Hot water on at controller for over an hour this morning and from cold the cylinder only got to 25ish Had it on since 6 tonight...
  20. H

    Programmable wireless Room Stat for Vaillant & WB

    Has anyone tried the plug in programmable wireless room stat from SALUS for both WB (ST620WBC) and Vaillant ecotec (ST620VBC) combi boilers at a fraction of the cost of their own offerings.
Back
Top