Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

valve

  1. chchris

    Solenoid valve and pressure valve

    Hi, guys! Hope you are all well. I have four solenoid valves connected to the main water supply, and they seem to break quite often. I believe it's the pressure that's causing this. I was thinking of adding a pressure valve to control the pressure before it goes through the solenoid valve. Do...
  2. D

    Tempering Valve - Best Brands

    So my hot water tank is barely 3 years old and a recent service check tells me the tempering valve is on the way out It's a Hydroboss brand from Tradelink and I'm keen not to replace crap with crap So what are the best brands of valves on the market ? The plumber recommended AVG
  3. M

    Replacing Radiator with drain valve

    I want to replace a radiator that has a drain valve. Do I need to replace like for like and keep the drain valve in or can I replace with a thermostatic valve?
  4. B

    What happened to stop valve and hot water?

    Hi everyone, Could someone please explain if this set up is normal and what changed: Stopcock under kitchen sink turns off cold water supply in kitchen only Stopcock in kitchen wall panel turns off cold water supply in kitchen only Red gate valve in airing cupboard next to bathroom turns off...
  5. M

    Controls and zone valve

    Is there anyway of testing electrically with a multimeter or any other way. Of testing that when you turn a room stat up it is creating a demand and opening the zone valve? Thank you
  6. J

    Diverter Valve / No Heating Help

    Hi,

 Our heating stopped working today. We've got a Veissmann boiler that's under a year old, and an older Megaflow cylinder, and two diverter valves (all about 10 years old). We also use a Hive thermostat.

 When I boost the hot water with Hive, the receiver near the boiler shows it's...
  7. A

    Strange Radiator Valve Screw

    I need to turn on a radiator and want to remove the valve top to put a spanner on it as it as it is stiff, however the screw holding it on looks like a security screw as it has two holes in it. Has anyone seen these before?
  8. P

    alternate straight through CH return valve for combi

    I'm in a bit of a bind with a current CH install where I need to install a filter prior to a flush but no where to install My issue is the return on the combi (ideal 35) runs directly behind the boiler then up through the ceiling so I have no clearance to even attempt to snake it out to fit a...
  9. D

    Valve in street inaccessible - water company obliged to fix?

    Hi! Our main stopcock is weeping. I phoned the water company, first-person thought it was their problem as it was on the 'outside' of the water meter. Then another person called me to schedule a visit and they told me that its not their problem as both the water meter and the leaky stopcock are...
  10. S

    Shower valve issue. Hot and cold mixed up.

    Hi all. My hot water feed for my shower is on the left and the cold is on the right. My understanding is that this is correct and this is also stated in the instruction manual for my valve. However when I turn the mixer clockwise cold water is coming out the shower instead of hot water. When...
  11. S

    Shower valve issue. Hot and cold mixed..

    Hi all. My hot supply for my shower is on the left and my cold feed is on the right. My understanding is that this is correct and this is also stated in the user manu.al. However when I turn my mixer clockwise the water is turning cold when it should be hot. When I turn it anticlockwise the...
  12. R

    Three-way diverter valve -electrical problem

    Hi I have a fully pumped heating system fitted with a Drayton MA1 diverter, after the summer run the heating stopped coming on, so I replaced the Actuator head, however I have found the actuator is stuck on H (Heating), I have turned down both heating and cylinder stat - still stuck on H. The...
  13. S

    Unvented cylinder/shower valve

    Hi All I had an unvented cylinder fitted about 6 years ago. It only supplies hot water to my shower. I was hoping for a much better flow rate from the shower but it seemed no different from the original combi boiler hot feed. There is (unusually) a lever that lets me select the combi or the...
  14. S

    Pressure Relief Valve Behind Washing Machine Problem

    Hi, all. I have a leak problem behind the washing machine. It's a pipe that is leaking directly into a drain. It used to drip but now is leaking a steady stream without stopping. Seems to be coming from water heater but I cannot tell. It is cold water. When I turn off the main water supply, it...
  15. M

    Concealed cistern fill valve.

    Has anyone got an idea what make concealed cistern this maybe? I need a new full valve for it. Thanks
  16. B

    Recommendation for Radiator Bleed Valve

    I bought the a bleed valve from S****fix about a year ago: s****fix.com/p/radiator-vent-blanking-plug-nickel-2-pack/40972 It worked fine initially, but I noticed that the little bleed screw needed to be turned a little tighter each time I bled that radiator to seal it up again. Having bled it...
  17. SamTylersJacket

    Is this a isolation valve?

    Is this a isolation valve?
  18. N

    3 way valve not working got hot water no heating help

    I have an old Potterton suprima boiler with a hot water tank and pump. We have hot water but no heating, the light on the boiler is showing amber (no call to heat) I have been told that this is likely due to the 3 way valve or motor on it (Myson Power Extra). I am wondering whether to try and...
  19. M

    Please identify divertor valve

    Can anybody identify the make of this divertor valve. Actuator is missing!! Cheers.
  20. B

    How to fit McAlpine ARB-1 anti rodent valve?

    I am trying to fit an anti-rodent valve ARB-1 to a MacFit MAC-1 WC pan connector. Instructions for the valve say"remove ..... ribbed seal" from WC connector and discard. But as far as I can see the seal is bonded to the WC connector and is not removable. Would be grateful for advice if someone...

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Back
Top