About twenty years ago, we had an extension built with a utility room for washing machine and tumble dryer. We've been through four or five washing machines since then and I have simply pushed the washing machine drain onto a tapered nozzle which screws on the end of the trap.
Recently, Mrs...
Hi all, so we've had to have our washer moved and a plumber installed it next to the sink. Since then the sink has made a gurgling noise whenever the washer is running, and I don't mean once or twice while it's draining, it's quite often and even when the bowl is actually spinning. The plughole...
Hi
Scenario,..... I go to install my new Washing machine and the little shut off valve has Seized solid and i can not access the mains water shut off valve,
In the past i would bend the fill pipe in half and put a jubilee clip on the bent section while im working on it.
Is there a specific...
Hello
Installing washing machine in remote location under stairs/ no drain near by
here’s what I’m proposing but never done before so thought I’d have an ask,
Fit washing machine with hose into hockey stick trap then connect to Grundfos sololift C-3 lifting station, core through the wall to...
I bought a new washing machine, it had bad water hammer and started leaking from the inlet valve (plus a couple of other issues) so I exchanged it for the same model. The new one seemed fine at first but after a couple of washes has water hammer. Is the problem with the machine do you think, or...
Hello, we just moved into a house in the Netherlands and are struggling to fit our washing machine. We have a Samsung washing machine with the standard 1/2 in inlet pipe. The wall has a fitting I've never seen before which after research is a flamco safetap (Google Image Result for...
Washing machine standpipe issues
So I moved into an old house and the laundry area just has this standpipe sticking out of the floor. Cannot access crawlspace to see if there's any type of trap under the floor. We believe the pipe just makes a 90° turn under floor to meet up with other drain...
When the installer came to install my washing machine, he was mystified about the pipe attachment in my house. The metal pipe doesn't appear to have any threading, just a bolt around the end. Because of this the standard pipe attachment doesn't connect.
Do I need to buy some kind of adapter and...
Hi
We have had an issue with our system for a few weeks now, the pipes judder and vibrate behind the wall, where the bathroom sink is. We have had a Megaflow system taken out and replaced with a Combi this week, and I had expected the noise and vibration to go aware.
Its kind of got worse...
Hey, just looking for a little feedback on the mock up I drew. I’m adding a washing machine and a double vanity to a 2” pipe I’ll have mounted into my main drain stack. For the vent off of the vanity, is it necessary? I’ve seen an “all hub 90” that would give me pipe to both vanities, but...
Have a problem with water hammer on washing machine, solved it for a bit with a mini rester been thro 2 seem to only last a year or so and expensive. So purchased a 1/2" T and a 0.16L mini expansion vessel and T what pressure should it be set at? When I first used machine it seemed ok then few...
Hi i am new & useless at DIY i have old bulky plastic taps connected to my washing machine - due to new units being fit i need 3 cm more space at the back so can i replace with smaller taps? also as the washer is 10yrs old can i cap one off ..if so which one,, hot or cold? i appreciate your time...
My clothes washing machine drain pipe overflowed water when the machine was emptying, so I augered the pipe over 15 feet and I even had a plumber do the same while he was there for something else. But when I poured water into the standpipe to check it before using the machine again, the water...
Hi All, I recently moved house and the waste pipe in my new home is significantly smaller than my last. It measures 25mm. I am having trouble decifering which sized spigot to get and I'm also having trouble finding anything smaller than 35mm (which bought and is too big).Pics attached. Advice is...
Hello
My daughter's Indesit Washing Machine is repeatedly filling with sewage and toilet paper up to approximately half way up the drum. She lives in a basement flat with 3 other flats above. She has had numerous Drainage Experts and Plumbers out under the British Gas Homecare Agreement who...
Hi! Sorry we are first time buyers! So May be a stupid question! The water hose for our new washing machine doesn’t fit the water inlet? (Photos attached). It screws on but not all the way, and if I open the valve it sprays water everywhere. Do I need a connector or something? Any help/advice...
Hi all,
I’m having a problem with my washing machine and any help would greatly be appreciated!
I moved into my new build ground floor flat just over a year ago and I’ve always had a problem with my washing machine not working correctly and leaving my clothes with a damp/stagnant water smell...
Hello,
*Disclaimer: Please forgive the messy photos. Our small storage/laundry room is a never-ending clean/mess zone
I am attempting to move my washing machine so that we can actually have some space in our small laundry/storage room, but I am unsure if this is possible due to code/physics...