waste | Page 10

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

waste

Recent contents Top users
  1. M

    Replacing pop up plug and waste in bath. No screw to remove drain cover from plug hole.

    Hi, the pop up plug system has broken and needs replacing. I would like to replace the whole lot. My issue is trying to remove the waste drain cover from the bath isn't what I'm expecting. There is no screw holding the trap to the plug section in the bath. As the bath is fiberglass, I don't want...
  2. S

    What are my options replacing toilet with waste pipe in floor?

    A few years ago I had to replace my old, 1960's downstairs loo as it had a crack in it. I was told that, because the waste pipe went down into a hole in the concrete floor and because of the distance of that hole from the back wall (20cm), I'd need a loo with a concealed cistern in a large...
    • Sabina
    • Thread
    • floor pipe replacing toilet waste waste pipe
    • Replies: 4
    • Forum: Boilers
  3. I

    Is this a waste access point?

    I had to do work on waste pipe and uncovered this (as shown in the photograph) is it a access point that some one has either broken or left uncovered. There was just a cloth stuffed in it. It looks as though it is threaded. I would of investigated further but the people there were closing up and...
  4. M

    Waste water pump

    Hi can anyone recommend a good waste water pump. For clean water so won't need a macerator bit. It's for a waste run that now has 6 meters pipe with a fall of 20mm. So well out of limits for the required fall. Has been tested yet but I don't think will work without a pump.
  5. B

    Help -What is easiest option to fit double waste under sink ??

    Hi All Attempted to fit a double waste outlet today (w/machine and dishwasher) but failed. I purchase this from screwfix presuming i could i just swap/convert the current single hose outlet to a double but when i tried i realised it was for 40mm pipe/compression fitting and i could not just...
  6. B

    Advice Please -Fitting 60cm dishwasher? CW Supply and Waste?? Options???

    Hi All I am looking to fit a 600mm dishwasher, i will be fitting it under counter in a current 600mm 3 drawer carcass (i presume this is ok once all the drawres/side sliders are removed?) From left to right i have sink unit (single waste outlet on trap/u bend), space for washing machine (600mm...
  7. H

    Bathroom Waste Layout - Horizontal Soil Pipe

    Hello, I would very much appreciate some help/feedback on what I am proposing for my very small ensuite bathroom. While refurbishing it I’m proposing to add a shower. It’s just 1.2m x 1.6m. I have seen similar posts to this on the forum but not quite my situation. I am proposing to run one...
    • HowardS
    • Thread
    • bathroom pipe soil soil pipe waste
    • Replies: 1
    • Forum: Boilers
  8. C

    Basin waste option

    Hi all, We are replacing our bathroom “hand wash basin on a table” with a basin on a new wall-hung cabinet with a drawer in it. The problem is, the waste pipe outside diameter is 36mm but the space behind the drawer is only 33mm Behind that gap is a 10mm wide strip of wood (about 30mm high)...
  9. M

    Slightly moving waste pipe connection into soil pipe

    Parents have had a steel beam put into their hallway ceiling to adequately support landing and stairs. This means that the waste from a sink and shower will need to be reinstated slightly lower into the soil pipe, as the pipes will now run under rather than through the beams (the joists will be...
    • Mrflibble
    • Thread
    • connection pipe soil soil pipe waste waste pipe
    • Replies: 29
    • Forum: Boilers
  10. T

    Help locating a rectangular waste trap for kitchen sink?

    Hi all, I am hoping someone can advise on this.....bought a 1.5 bowl sink a while ago from B&Q but never got around to fitting it. Now decided to fit it in my utility room but upon having a look at it the smaller of the two bowls appears to have a rectangular slotted waste exit in the bottom as...
  11. L

    Bath Waste Overflow Dilemma

    Can anyone suggest a compatible overflow waste that works with this Bath? Appleby Roll Top (freestanding) see link below. I don’t want to fit an exposed chrome Roll top type overflow that is often suggested . They are pricey for a start. Just require a simple standard one with Flexi tube and...
  12. P

    Outside waste drain constantly blocking.

    Hello all, We hope you are well. We are looking for some drainage advice on a relatively new build property. The drain outside of the property constantly blocks with toilet paper and waste every 5-6 weeks of use. Following the blockage we unblock by using hot water and essentially poking...
  13. U

    Tee basin into shower waste?

    Hello, have a 4m run of 50mm pipe for the shower. The layout of joists, closeness of corner walls etc mean that it would be very helpful to be able to add the basin waste to a swept tee in the shower waste and this could be between 300-800mm from the soil stack . I've read elsewhere very mixed...
  14. U

    Soil stack/waste connection different manufacturers pipe differences

    Hello. I'm connecting a long run of 50mm solvent weld waste pipe from a shower to the stack (compliant with regs hence 50mm). The soil stack branch is Hunter and I bought a Hunter solvent weld boss adapter to fit on it. However, the waste pipe (Floplast I think)is a loose fit in the adapter...
    • UserError
    • Thread
    • connection pipe soil waste
    • Replies: 0
    • Forum: Boilers
  15. M

    Macerator Waste Advice

    Hi So I am adding an en-suite to a downstairs bedroom and have to install a macerator. I will be using the SaniPlus Up. I was trying to get a professional macerator fitter but can't get anyone in the time frame (in the next 10 days) so I am trying to fit the waste piping from the macerator...
  16. S

    Help with leaking waste water to down pipe

    Hi Everyone, Can anyone tell me what's the best way to fix this leaky connection union? Does the connection to the main down pipe need to be horizontal? Looks a bit dodgy to me. Should I replace with the pipe layout with something like I have sketched with the red or green lines in the...
  17. C

    Has anyone fitted a combined bath trap and pop up waste like this one, who is manufacturer? Thanks

  18. E

    Shower waste hole slope: defect or ok?

    I have a 40 mm resin tray to install (sand/cement over suspended ground floor) and a decent McAlpine 90 mm waste. The hole in the tray is apparently on the built-in fall by accident or design, so that, with the ground-flat base, the edges of the hole vary from about 4 mm to about 8 mm on either...
  19. M

    Combining pushfit waste pipes

    Is it OK to combine osma, polypipe and floplast push fit waste pipe? I. E polypipe fittings and floplast pipe. Different merchants sell just one of the above. So I tend to end up with bits from different manufacturers. I presume its OK. I'm sure I have before and never had any issues. Just...
  20. S

    Re arranging waste pipes

    currently working on my bathroom refurb and am after some advice on how best to go about re arranging the following: Starting from the top: The sink waste is solvent welded but i can reuse it in its current position I want to move the toilet to the adjacent wall so id need to move the...
Back
Top