R
REDSAW
105e, turn on, pump runs, h/w light illuminates (no taps open) fan twitches. h/w and 50 (fan) neons flash=nothing.
changed all sensors or jumped them, aps, venturi clear and div motor swapped out. i got it fired up twice in an hour and that was it (when i swapped the div valve over). no 240v to fan at sequence.
upon reset if the h/w dial is in the off position, it does not trigger fault but boiler still dosnt work!
put down to pcb. any coments?:stuart:
changed all sensors or jumped them, aps, venturi clear and div motor swapped out. i got it fired up twice in an hour and that was it (when i swapped the div valve over). no 240v to fan at sequence.
upon reset if the h/w dial is in the off position, it does not trigger fault but boiler still dosnt work!
put down to pcb. any coments?:stuart:
Last edited by a moderator: