M
marshr02
Dear CORGI Guys
Looking for advice. I want to install my own boiler as much as possible without fouling CORGI rules & get a CORGI bloke in to connect gas, test & turn on.
My question is can I adopt the following approach:
1) Turn off the gas at the meter
2) Disconnect old boiler, including disconnecting the gas pipe to appliance
3) Tidy up wall & plaster etc, fit new boiler (less gas)
4) Get CORGI bloke in to check flue location, ventilation, and physically connect gas supply then test ,purge etc & turn on & give me the relevant paperwork
Any comments appreciated. I enjoy DIY etc and have an engineering degree - it's not because I'm trying to save money...
Looking for advice. I want to install my own boiler as much as possible without fouling CORGI rules & get a CORGI bloke in to connect gas, test & turn on.
My question is can I adopt the following approach:
1) Turn off the gas at the meter
2) Disconnect old boiler, including disconnecting the gas pipe to appliance
3) Tidy up wall & plaster etc, fit new boiler (less gas)
4) Get CORGI bloke in to check flue location, ventilation, and physically connect gas supply then test ,purge etc & turn on & give me the relevant paperwork
Any comments appreciated. I enjoy DIY etc and have an engineering degree - it's not because I'm trying to save money...