does a condensate waste now have to be 32 going through an external wall | Plumbing Jobs | The Job-board | Page 2 | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

American Visitor?

Hey friend, we're detecting that you're an American visitor and want to thank you for coming to PlumbersTalk.net - Here is a link to the American Plumbing Forum. Though if you post in any other forum from your computer / phone it'll be marked with a little american flag so that other users can help from your neck of the woods. We hope this helps. And thanks once again.

Discuss does a condensate waste now have to be 32 going through an external wall in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
Long run in overflow then just tell them if short under a m then chances it will be fine

One that stood out was in a garage, 22mm copper along 2 sides for say 25ft with little fall on the pipe, then outside down side of house for say another 15ft all without lagging.
 
One that stood out was in a garage, 22mm copper along 2 sides for say 25ft with little fall on the pipe, then outside down side of house for say another 15ft all without lagging.

That a good one hahaha
 
That a good one hahaha

Oh it gets better, where it pops outside through a half brick there is a compression 90 elbow taking it down to 6" above ground level then another 90 taking it to the rain water guttering downpipe where it enters the pipe and is sealed with a smear of silicone. Looks lovely! Not.
 
One that stood out was in a garage, 22mm copper along 2 sides for say 25ft with little fall on the pipe, then outside down side of house for say another 15ft all without lagging.

If it's in copper will be fine the cond water will eat through
 
Status
Not open for further replies.

Similar plumbing topics

  • Question
Best thing to do first is to read the relevant...
Replies
1
Views
520
Hi all, Pipe moved...Temporarily fed back...
Replies
5
Views
731
  • Question
Wolseley normally have 2” black solvent weld...
Replies
2
Views
1K
You're over thinking it, you're using 32mm...
Replies
13
Views
1K
10 o’clock / 45 degrees would be better than...
Replies
3
Views
678
Back
Top