glow worm gascom room stat wiring HELP! | Gas Engineers Forum | Page 2 | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss glow worm gascom room stat wiring HELP! in the Gas Engineers Forum area at Plumbers Forums

Status
Not open for further replies.
You completely fail to understand the message we've given that we are prepared to help you but not in open forum.

And to accuse members, including me, of 'trolling' because we have a sense of humour isn't going to happen.

Had enough of you now. Bye bye.
 
Would have been nice to see if he was an engineer or just chancing his arm.
 
got a call today, sparky had been and disconnected the pump that had water in the connector box. Custard wanted HW, but sparkie hadnt shown her how to turn on immersion, just left the wires hanging, charged a large fee and gone, the next plumbing co had taken a retainer am by card over the phone and done a no show, I asked for a picture (as I was the only lifeboat mechanic in town) and got a pic, pointed out the immersion switch over the phone, told her to turn off the boiler and controls and booked her in for monday. sparks had only taken out the pump wiring and left it hanging and live!! still off I went 10 minutes later, 2 rescues, a third later by the rubber duck as well, busy busy :)
 
Status
Not open for further replies.

Similar plumbing topics

I once had a similar experience with my old...
Replies
6
Views
957
S
Boiler Fault I’m hoping someone can help with...
Replies
0
Views
182
S
No taps or showers have been replaced. We did...
Replies
2
Views
1K
  • Question
Thanks, the installer had linked a permanent...
Replies
14
Views
2K
A
Thanks for that. And yes, time for an engineer!
Replies
2
Views
1K
Andy Don
A
Back
Top