Rob Foster
Esteemed
- Messages
- 2,083
Glowworm 100ff wall hung 30kw conventional boiler. Set up in garage with correct 28mm runs to rest of system. All worked well over the years odd new bits and bobs. Recently serviced It goes through start up sequence fine style.
Call on from timer in house, fan starts, pump on, starts ignition sequence spark ignites pilot gas - pilot established and bingo ...............28mm out starts to heat up but after about 10 mins ------------------------- shut down. Cool down and will do it all again. All rads (12 rads) are open and 3 way for cylinder is always open. Rads start to heat up. So whats the problem ? I think maybe pump is lala despite being new 3 years ago and runs smoothly. No airlocks centralheating water out of bleeds on all 3 levels of the gaff. The only control for heat is on the boiler and set at 3/4 full heat. Any ideas. It does not get to modulation in 10 mins - house is too big
Thanks in anticipation
Call on from timer in house, fan starts, pump on, starts ignition sequence spark ignites pilot gas - pilot established and bingo ...............28mm out starts to heat up but after about 10 mins ------------------------- shut down. Cool down and will do it all again. All rads (12 rads) are open and 3 way for cylinder is always open. Rads start to heat up. So whats the problem ? I think maybe pump is lala despite being new 3 years ago and runs smoothly. No airlocks centralheating water out of bleeds on all 3 levels of the gaff. The only control for heat is on the boiler and set at 3/4 full heat. Any ideas. It does not get to modulation in 10 mins - house is too big
Thanks in anticipation