- Messages
- 10
Hello,
I have a boiler engineer coming out, but it's not till next week, so I was just curious if anyone knew what this fault could be in case it was something obvious, it's the first I've tried heating since May...
Ariston Clas HE EVO38
No error messages, hot water is fine, but no heat. Even after putting the RF unit in override (however it is syncing ok and I can see the connection triggering to turn the relay on when I ask it), the boiler doesn't trigger.
However, if I hold the reset button and perform a 10 minute maximum heat test it works just fine. Pressure is 1.5bar and goes up over 2bar when it turns on as it's always been.
Any ideas?
Thanks.
I have a boiler engineer coming out, but it's not till next week, so I was just curious if anyone knew what this fault could be in case it was something obvious, it's the first I've tried heating since May...
Ariston Clas HE EVO38
No error messages, hot water is fine, but no heat. Even after putting the RF unit in override (however it is syncing ok and I can see the connection triggering to turn the relay on when I ask it), the boiler doesn't trigger.
However, if I hold the reset button and perform a 10 minute maximum heat test it works just fine. Pressure is 1.5bar and goes up over 2bar when it turns on as it's always been.
Any ideas?
Thanks.
Last edited: