Hole in gas pipe! | Gas Engineers Forum | Page 2 | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Discuss Hole in gas pipe! in the Gas Engineers Forum area at Plumbers Forums

Status
Not open for further replies.
Nice!!
i have a 117 and 323.

think we are sorted for a while!

get the magnetic strap for the back, so handy just hanging it on a boiler casing

Yep, iv ordered one of them too... Not cheap for what it is, but I like my tools :) nice long leads on these fluke meters too :)
 
was talking to a guy on a course a while back whos mate died feeding copper pipe under floor it snagged so twisted and pushed and the open end cut a shower cable on an old consumer unit .I now when pushing pipe under boards solder an end cap on - made me shiver
 
was talking to a guy on a course a while back whos mate died feeding copper pipe under floor it snagged so twisted and pushed and the open end cut a shower cable on an old consumer unit .I now when pushing pipe under boards solder an end cap on - made me shiver

Makes me shudder just thinking about it :(
 
Had it happen to me when pulling a cable out the way. The cable was an old rubber covered type and part way along the length the insulation had perished and turned to powder so when it was pulled, the wires touched each other. Made a terrible flash and bang and burning rubber smell.
 
Status
Not open for further replies.

Similar plumbing topics

  • Question
Hello, I am just catching up on some threads...
Replies
1
Views
626
Nedis Plug-In LPG, Natural Gas and Coal Gas...
Replies
10
Views
1K
Is the gas pipe magnetic?
Replies
3
Views
3K
the Same position for meter but riser outside...
Replies
3
Views
2K
Back
Top