I have a leak under my sink

[Huggy2822]

I have leak at this joint if too much water goes down my sink, I would be grateful for any help. Thanks

 

[ShaunCorbs]

Have you tried tightening the nuts ?

 

[Huggy2822]

Yeah, I've tried tightening the nuts, both nuts don't seem to tighten. Just continue to spin round

 

[ShaunCorbs]

Try pushing them apart a smidge and then tighten eg pull the left one slightly while tighten and push the right one slightly eg to the threaded parts

 

[SimonG]

All looks twisted and strained. Undo those nuts and make sure the rubbers are straight and not nipped or trapped.

 

[Huggy2822]

Thanks for advice guys, I will give it a try tomorrow

 

[gmartine]

Definitely looks like a cross thread and that T piece looks rather forced so you probably haven't made a proper seal. If you have any pipe left I'd make that connection piece a little bit longer or as Shaun said move those compression fittings apart and true them up.

 

[Huggy2822]

The rubbers had nipped and wasn't making a proper seal. Thank you very much everyone