I am fitting my first low loss header onto an unvented system including ufh and 300ltr tank. I have picked the job up after the ufh has been layer, tested and screened over. All I have to work with is the manifold with flow and return pipes and pre installed rad circuit all of which feed into the garage. I know how to set up the unvented system with zone valves, iso's, prvs etc but not how to and where to include the pump and how to wire it up and the arrangement of the low loss header.
Any advice would be great.
I will be installing either Worcester or viessmann.
Any advice would be great.
I will be installing either Worcester or viessmann.