Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Making a diy decarbonizing heater for my bbq gear??

mutley racers

Esteemed
Plumber
Gas Engineer
Subscribed
So just a thought, do you think it is possible to use a 40ltr garden waste bin by just putting an immersion heater in the lid and just put a plug on the cable and plug it into a socket for in my garage? Maybe set it to 50degrees? Am pretty sure the plastic would not melt at this temperature.

What do you reckon?

If so, can you buy a female tank connector this side?

I hate scrubbing bbq stuff!!!

Or maybe use a stainless steel bin?

Ideas would be great

Thanks
 
also, whats grade D? I get ya i think, fold the cylinder in where i cut it

Grade D plumbers solder
grade d.jpg
Sold in 1lb bars, 30/70 tin/lead used for wiping joints. Drill a 2½" hole, tin (apply solder) about an 1½ around the hole. Stick the immersion (it is made of brass) in and wipe a joint with grade D (a bit greasy thin cardboard will do to wipe with if you don't have a moleskin). Cheaper than an essex flange :wink:
If your immersion is too long bend it in 2. Just don't go too tight on the radius but it willl bend tight enough to fit through the hole.
Simples as they say :lol:
 

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Back
Top