Hi . Trying to work out best way to get hot water to two horse washing stables. What is there now is a block of old stables. At one end is two large water tanks feeding each stable water troughs. They want hot water to wash the horses down using the last two stables which is 50m away from cold tanks. If I put a cylinder with 2 immersion heaters below cold water tanks then the hot water would have to travel 50m at 0.2 bar pressure to point of use.could take a while.
I could put the hot water cylinder near the end stables being used with supply from cold tank insulated, but if I run the vent pipe back to the cold water tanks that is 50m away. Does the vent pipe have to vent over cold water tank?
Putting a combination tank height in the stables is going to be difficult as no where to build a platform and suspect old beams may not hold 160kgs
Any suggestions would be welcome
I could put the hot water cylinder near the end stables being used with supply from cold tank insulated, but if I run the vent pipe back to the cold water tanks that is 50m away. Does the vent pipe have to vent over cold water tank?
Putting a combination tank height in the stables is going to be difficult as no where to build a platform and suspect old beams may not hold 160kgs
Any suggestions would be welcome