taps | Plumbing Jobs | The Job-board | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

taps

Post thread

Discuss taps in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
T

Tonto123

Got a set of kitchen taps... it says minimum operating pressure 1bar... the mains should be ok... but the hot im not sure.. the hot water cylinder is upstairs.. would it need to be pumped to get 1 bar for the hot
 
yes, these taps are for unvented or combi's. you will have poor hot flow.
next time look for .2bar.min
 
Status
Not open for further replies.

Similar plumbing topics

S
Advice needed for a mixer Spray for kitchen ?
Have you got a photo of the sink at the...
Replies
2
Views
632
Lou
Lou
D
  • Question
DHW supply from Vaillant turbomax 828e
I think 2.7LPM is the minimum requireed so...
Replies
4
Views
370
John.g
J
C
  • Question
Best place to source low pressure bath filler taps
Sorry for the delay in replying, I had an...
Replies
12
Views
986
Coddey
C
nashant
  • Question
Vibration when first opening hot tap after u/v cylinder heating cycle
And it's fixed! Had someone move the EV from...
2
Replies
27
Views
3K
nashant
nashant
L
  • Question
Mains supply to mixer tap is pushing cold water to hot water pipe
Thanks.
Replies
4
Views
1K
LordWest
L
Back
Top