Hi all,
Hope you are well.
Looking for someone to convert a combi system to an unvented system. Also, at the same time renew the cold feed from a 15mm to 22mm to the tank, install 1 new radiator, and replace 5 existing radiators.
The new boiler will replace the existing boiler in a reception room; the tank will be sited a couple meters away in the cellar. Pipe access should be straightforward from the cellar the wall in that location could be knocked through.
I have already ply lined the cellar in that location, levelled and laid a flag stone for the tank and brought in a pipe for the tundish from a working drain to within a couple of meters of where the tank will be sited.
I would like an aerator, magnet and both expansion vessels to be sited in the cellar near the tank along with a filling look and an additional pressure gauge.
I would like either a Baxi Platinum 32kw or a Viessman Vitodens 100 30kw with a Joules 300l cylinder.
The gas is 28mm to within 2 meters of the existing boiler on its own feed, 22mm thereafter.
I would also like the system to be power flushed before the new install.
I think a good way to tackle this is to setup the tank first and get that working with the immersion heater then power flush and replace the boiler, then radiators and connect it all up. However, this is just my opinion.
I have measured our cold feed pressure and flow rate, of which we are getting 3 bar pressure (2.5 dynamic) and 20-22 litres per minute of flow.
This is for my mother’s property; she is currently terminally ill and claiming PIP if that helps with the current grants available.
See pictures below for some guidance on this job.
Any help is greatly appreciated.
Thanks in advance.
Kind regards and happy holidays.
Sal
Hope you are well.
Looking for someone to convert a combi system to an unvented system. Also, at the same time renew the cold feed from a 15mm to 22mm to the tank, install 1 new radiator, and replace 5 existing radiators.
The new boiler will replace the existing boiler in a reception room; the tank will be sited a couple meters away in the cellar. Pipe access should be straightforward from the cellar the wall in that location could be knocked through.
I have already ply lined the cellar in that location, levelled and laid a flag stone for the tank and brought in a pipe for the tundish from a working drain to within a couple of meters of where the tank will be sited.
I would like an aerator, magnet and both expansion vessels to be sited in the cellar near the tank along with a filling look and an additional pressure gauge.
I would like either a Baxi Platinum 32kw or a Viessman Vitodens 100 30kw with a Joules 300l cylinder.
The gas is 28mm to within 2 meters of the existing boiler on its own feed, 22mm thereafter.
I would also like the system to be power flushed before the new install.
I think a good way to tackle this is to setup the tank first and get that working with the immersion heater then power flush and replace the boiler, then radiators and connect it all up. However, this is just my opinion.
I have measured our cold feed pressure and flow rate, of which we are getting 3 bar pressure (2.5 dynamic) and 20-22 litres per minute of flow.
This is for my mother’s property; she is currently terminally ill and claiming PIP if that helps with the current grants available.
See pictures below for some guidance on this job.
Any help is greatly appreciated.
Thanks in advance.
Kind regards and happy holidays.
Sal
