Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
Questions and plumbing advice in the Showers and Wetrooms Advice - Whether a tiled sealed shower using a tray former and tanking, to create a wet-room. Or even just plumbing in an electric shower or shower using jets or mixer taps. Ask a plumbing question in here..
Normal Threads
I need to replace a faulty Bristan valve as neither the valve nor cartridges are available. I...
- IanRowlings
- 17
- 6K
- Latest:
- Harvest Fields
Hi,
I am a newbie......just bought an older house looking to fix it up. Just didn't realise how...
- AndreaB
- 3
- 1K
- Latest:
- sammathias
Ehup peeps , a customer has asked me to fit a new quadrant enclosure on to an existing tray .
I...
- townfanjon
- 5
- 1K
- Latest:
- townfanjon
Hi,
Just joined the forum this evening.
I need some help/advice
The problem....
Past month or...
- Telemacus
- 3
- 726
- Latest:
- ShaunCorbs
I'm after some fixings for a Shower tray former. To be a little more precise it's the washers...
Hi all,
For some reason my shower will not stay hot, it is hot for about 30s and then will go...
Hello, I had a new bathroom installed 18months ago, I have since discovered a leak under the...
Problem was bath mixer going from hot to cold every few mins, I first thought it was a boiler...
I have been recommended CT1 as a sealant for a shower waste.
Is it recommended to apply sealant...
I've just installed a new shower tray and have used the product below to act as the seal between...
- Don
- 17
- 21K
- Latest:
- C McC
Hi there,
Looking to install a thermostatic mixer shower in a flat with night rate unvented...
- Ric2013
- 9
- 2K
- Latest:
- Ric2013
Does anyone know a shower that I could swap with this one without to much work?
Hoping for a...
- southcoastboile
- 8
- 1K
- Latest:
- southcoastboile
Hi,
(Homeowner, first post – apologies in advance if I'm doing this wrong) –
Is it possible to...
Hi all
I need some help, I'm really hoping you guys can give me some advice!
I'm a 2nd year...
- CatAdelova
- 20
- 3K
- Latest:
- Best
Hi,
I've just moved into my new home and it has the above installed. Operation of the shower...
- Louis
- 2
- 3K
- Latest:
- Louis
Hi, shower hasn't been draining properly recently, not blocked but slow to drain.
Can anyone...
I have a Bristan mixer shower that keeps going cold, it goes cold for a minute or so and then...
Hi folks - I'm after some help with a shower trap that I need.
I've got a 110mm pipe popping up...
- jewellers
- 4
- 1K
- Latest:
- king of pipes
Need some advice. I have a mixer tap in the bath basin(see attached photo). I believe there are...
- totalamateur
- 6
- 10K
- Latest:
- Harvest Fields
Hi,
I've had a new bathroom installed and all is well apart from very wobbly fittings. I've got...
- Davex#1
- 20
- 4K
- Latest:
- moonlight
I need to replace an exposed thermastatic shower valve with 22mm inlets and centres of 140mm...
- Mark Ranford
- 1
- 1K
- Latest:
- jtsplumbing
Had to run pipework to digital shower in loft. Had it been my job, it would probably have all...
Hi everyone
Started a job today, bath out and put in tray.
I've advised against it but cust...
Hi,
I have an Electric shower (cold incoming pipe only) in my en-suite shower unit and due to...
Hi,
I have a gravity fed traditional system (header tank in loft, hot water cylinder below, gas...
Hi
Newly installed Bristan bar shower, hot comes out lukewarm only.
Have set the cartridge to...
- armyash
- 19
- 141
- Latest:
- jonnyswamp
Went to a house today to look at a shower running like warm. All other outlets run hot water...
Mira Platinum dual rear fed digital shower standard
We've just had this shower fitted, but it...
- ChaZ1
- 5
- 2K
- Latest:
- Christopher buzzard
I have just had a brand new bar shower mixer but the shower head keeps dripping every now and...
- simbadoggy
- 6
- 3K
- Latest:
- simbadoggy
Hi, hoping someone can help me. I just replaced the shower hose due to the old one leaking at...
- Fergilico
- 5
- 9K
- Latest:
- rpm
New Threads
-
-
Vaillant echTEC Plus 838H over pressurisingHello. Not to long ago I took off a radiator...
- Started by lee2lee
- Replies: 0
-
-
Issue replacing 22mm pipe on central heatingHi all I was hoping to make good this corner...
- Started by kristeva
- Replies: 4
-
-
Inspection chamber leakWould someone be able to advise please. I’ve...- Started by BobThomas
- Replies: 8
-
Aliddin easyfit isolator, Anyone with a bad experience of these?Hi all, thinking of fitting the said isolator...
- Started by Barry
- Replies: 2
-
Ultra compact wall hung toilet frameI'm redoing our 4' x 4' downstairs loo. My...
- Started by UserError
- Replies: 1
-
-
So... Does anyone know what this is??As I said, any ideas what this is for? It was...
- Started by Jonnyfrance
- Replies: 5
-
Potterton Promax 15 HEBeen called out to an issue with a Potterton...
- Started by MethodPH
- Replies: 3
-
Best flush cones for low level cistern connections?Any recommendations other than the usual clear...
- Started by macka09
- Replies: 4
-
-
customer wants boiler in unheated storeroomunheated storeroom, with louvre doors open to...
- Started by Gasinspect
- Replies: 2
-
Seized Filling Loop TapHi, any ideas on how I can get this seized tap...
- Started by fadsarmy
- Replies: 1
-
Non-return rat flap/blocker at drain exitHi folks! I have a question re rat flaps /...
- Started by Johnfella
- Replies: 1
-
Texture metal lined pipe?Hi guys Any of you use the above pipe at all...
- Started by macka09
- Replies: 4
-
Rusted screw removal tool??Hi guys any advice on removing rusted screws...
- Started by macka09
- Replies: 0
-
An Boiler be left on with water tuned off?I have a Worcester Greenstar boiler and would...
- Started by Traveller 47
- Replies: 9
-