Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
Questions and plumbing advice in the General DIY Plumbing Forum - Ask DIY related questions in this forum.
Normal Threads
I need a 2 channel programmer that has a backlight. I have a couple but the backlights are not...
- Bogart
- 5
- 1K
- Latest:
- Bogart
Hi guys
Im replacing a set of basin taps with a v&b mixer tap.
The flexi tails attached to the...
- Serval
- 7
- 2K
- Latest:
- ShaunCorbs
My central heating was installed in 1978. Over the years only two boilers have been used...
I found I had a dripping radiator last night. Stemming from under the radiator i think its...
Yes it me again with another question. I keep reading that one will get a better flow rate in an...
Hi guys. There's a bit of reading in this but I'll try keep it short as possible.
We noticed...
- Callaghan88
- 10
- 2K
- Latest:
- ShaunCorbs
I've done this on so many taps without problem but...
I just can't seem to see how to get at...
My immersion heater tripped the mains breaker, when I took the cap off it was full of water and...
This Smeg Modena tap is dripping from the hot cartridge. I've got the replacement ready to go...
- AlphaHotelBravo
- 8
- 3K
- Latest:
- AlphaHotelBravo
Am replacing a rubbishy old waste trap and have bought the McAlpine 1.5-2 sink kit with 40mm...
- daves61
- 3
- 1K
- Latest:
- ShaunCorbs
Have a couple of rads that will get covers, so to have the trv outside the cover I bought a...
Trying to get the 3 port valve off so I can get on with changing from Y plan to S plan. Problem...
Hello,
Hoping someone can help! Not sure what else to try.
We have a Vaillant eco tec boiler...
- TallulaB
- 8
- 2K
- Latest:
- ShaunCorbs
I cut the old leaky coal boiler out of the system over the summer. It was piped in parallel with...
Can I ask what you guys use if you need to extend the cable that comes with a 2 or 3 port valve...
I started out life as an electrical engineering student then apprentice in an electric control...
- stuartg
- 15
- 2K
- Latest:
- stuartg
I want to solder a 15mm end-feed elbow onto a straight run of pipe to join it up to a radiator...
My magnetic scale inhibitor is coming to the end of its 10 year life and needs replacing. This...
I have just bought a new Drayton Wiser Kit 1 off the internet one of the TRVs has the collar...
- dfstrottersfan
- 6
- 2K
- Latest:
- dfstrottersfan
Need a few trvs any suggestions as to decent ones at a fair price. I can get Pegler Terriers for...
- Bogart
- 23
- 6K
- Latest:
- Bogart
Hi
I want to replace the silicone/rubber o rings on my washing mashine outlet flowpipe...
- joeblow47
- 3
- 1K
- Latest:
- joeblow47
Recently fitted an ST shower pump that is not yet in use as im still doing the rest of the...
- Serval
- 4
- 1K
- Latest:
- rpm
hi there. immersion hasnt been heating water.
tests resistance and wiring and all is ok. but the...
One of the reasons I have seen for not routing the condensate from an extractor fan outlet into...
- sxdave
- 6
- 945
- Latest:
- sxdave
As I am not on mains drainage, I have a treatment plant, any suggestions as to how to flush a...
Hello. I'm removing a sink temporarily to have flooring fitted. The pipe isn't fitted with a...
I'm in the middle of refurbing my bathroom, I have removed all the plasterboard, back to the...
- superflo
- 1
- 1K
- Latest:
- ShaunCorbs
Hi,
I am replacing an old towel rail that has started leaking with another old one the same...
- timc1960
- 13
- 2K
- Latest:
- ShaunCorbs
Hi. I've been having issues with a betacom 28 not delivering hot water.
I spent around £600 on...
- andyjacko1985
- 2
- 1K
- Latest:
- oz-plumber
I have a double sink, and the small sink is about 29cm x 15cm, and 12cm deep. When filled, the...
New Threads
-
Vaillant echTEC Plus 838H over pressurisingHello. Not to long ago I took off a radiator...
- Started by lee2lee
- Replies: 0
-
-
Issue replacing 22mm pipe on central heatingHi all I was hoping to make good this corner...
- Started by kristeva
- Replies: 4
-
-
Inspection chamber leakWould someone be able to advise please. I’ve...- Started by BobThomas
- Replies: 8
-
Aliddin easyfit isolator, Anyone with a bad experience of these?Hi all, thinking of fitting the said isolator...
- Started by Barry
- Replies: 2
-
Ultra compact wall hung toilet frameI'm redoing our 4' x 4' downstairs loo. My...
- Started by UserError
- Replies: 1
-
-
So... Does anyone know what this is??As I said, any ideas what this is for? It was...
- Started by Jonnyfrance
- Replies: 5
-
Potterton Promax 15 HEBeen called out to an issue with a Potterton...
- Started by MethodPH
- Replies: 3
-
Best flush cones for low level cistern connections?Any recommendations other than the usual clear...
- Started by macka09
- Replies: 4
-
-
customer wants boiler in unheated storeroomunheated storeroom, with louvre doors open to...
- Started by Gasinspect
- Replies: 2
-
Seized Filling Loop TapHi, any ideas on how I can get this seized tap...
- Started by fadsarmy
- Replies: 1
-
Non-return rat flap/blocker at drain exitHi folks! I have a question re rat flaps /...
- Started by Johnfella
- Replies: 1
-
Texture metal lined pipe?Hi guys Any of you use the above pipe at all...
- Started by macka09
- Replies: 4
-
Rusted screw removal tool??Hi guys any advice on removing rusted screws...
- Started by macka09
- Replies: 0
-
An Boiler be left on with water tuned off?I have a Worcester Greenstar boiler and would...
- Started by Traveller 47
- Replies: 9
-
-
Boss your bathroom - Join the Tile High ClubTrade Account Victorian Plumbing 10% off for...- Started by Dan
- Replies: 0