Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
Questions and plumbing advice in the Plumbing Jobs | The Job-board - .
Normal Threads
I opened up a heating pump today. Jammed in a screwdriver and stopped it spinning without too...
Morning everyone
My second job today is a saniflo macerator only connected to a toilet.
Got...
- vic89
- 5
- 1K
- Latest:
- rpm
I am going to replace hot and cold 15mm copper pipe with a plastic system. The hot water is...
hi need to replace a flue on a biasi M90f 24s boiler. Does anyone know which flue fits?
Thanks
- Theo1990
- 11
- 2K
- Latest:
- hammers4spanner
Hi everyone
Called out to carry out a boiler service on a junior 28i picked up the seals before...
Hi Guys. Still new to oil breakdowns. Got a Grant Vortex not giving CH. MI’s say (as far as I’ve...
Hi,
Just after an opinion on where to tap off the HW Cylinder to feed a downstairs shower...
Morning,
What do you pay for full bore lever valves, 15 & 22mm?
Personally I've found Williams...
hi lads,
Could anyone tell me if it’s mandatory to connect a condensate pump to the boiler?
I...
Hi. Very much a DIY’er but I’m installing a new radiator and just a bit concerned that when I’m...
hello everyone thought I give this ago,I’m a fully qualified plumber nvq looking for a gas...
- Jpeely
- 4
- 2K
- Latest:
- Sanjay Savani
Anyone fitted one?
Whats the difference between the new one and the 3rd gen?
- Scott_D
- 2
- 2K
- Latest:
- ShaunCorbs
I am still having endless grief trying to get customers to pay up on completion. Wether its 50...
- hammers4spanner
- 21
- 344
- Latest:
- Scott_D
Hello,
I'm replacing my hot water tap, but only now I realized that the hose nut is bigger than...
anyone know if it's possible to use a tado smart thermostat with a vokera 25he?
at the moment...
Hi All,
We have a older Version Worcester Bosch 35CDi Boiler (probably for about 15+ years). We...
- Bazzy
- 12
- 6K
- Latest:
- fezster
Hi can anyone help. Last year a new towel radiator was fitted in our bathroom. It was fine until...
Evening guys,
Whats the best stuff to use to clean up a radial heat exchanger. (Baxi duo tec 33...
- Allgoode
- 7
- 139
- Latest:
- ShaunCorbs
Hi All,
Just joined up so thought I'd drop a note to say hi!
Sam
- ForgePlumbing
- 6
- 705
- Latest:
- chris watkins
Hi everyone
Just saying hello as just joined forum.
- markymark99
- 12
- 1K
- Latest:
- markymark99
Just saying hi and thanks for the welcome Lou.
I'm a heating engineer working for a large...
So started a job today to fit a wetroom..currently has a concrete floor with wet UFH...
DOH...
- jaydebruyne
- 17
- 232
- Latest:
- jaydebruyne
Hi all,
I mainly work on commercial projects but a friend of a friend has asked me to re fit 2...
- MOSSEP
- 23
- 496
- Latest:
- Jim Goodenough
Attended this on friday heating and hotwater cut out after about two minutes , slow flash on...
- hammers4spanner
- 13
- 170
- Latest:
- Last Plumber
hi lads,
I hope you are all well.
I just wanted to double check with you am I allowed to...
For the first time, I have moved to a new house fitted with an unvented system so I have no...
Only showing temp setting on right and 2 dots on left (presume they're the dots between where...
- whatsthenews
- 6
- 1K
- Latest:
- whatsthenews
Hi, I'm fitting an outdoor sensor on my VIESSMANN 100 30KW B1KC. The wiring is finished, just...
Hi, I have two pressure valves on my central heating system. One is built into the boiler and...
- BlackMesaUK
- 5
- 815
- Latest:
- Last Plumber
Can 40mm solvent ABS (e.g. Floplast) be glued into a 40mm pressure solvent PVC (unknown...
New Threads
-
Are Pipe Heaters Safe?I have an ouside garden tap that freezes every...
- Started by Traveller 47
- Replies: 0
-
Choice of pipe for hot water secondary/recirculating systemWhat plastic based / barrier pipe can you use...
- Started by Failte
- Replies: 7
-
-
Vaillant echTEC Plus 838H over pressurisingHello. Not to long ago I took off a radiator...
- Started by lee2lee
- Replies: 0
-
-
Issue replacing 22mm pipe on central heatingHi all I was hoping to make good this corner...
- Started by kristeva
- Replies: 4
-
-
Inspection chamber leakWould someone be able to advise please. I’ve...- Started by BobThomas
- Replies: 8
-
Aliddin easyfit isolator, Anyone with a bad experience of these?Hi all, thinking of fitting the said isolator...
- Started by Barry
- Replies: 2
-
Ultra compact wall hung toilet frameI'm redoing our 4' x 4' downstairs loo. My...
- Started by UserError
- Replies: 1
-
-
So... Does anyone know what this is??As I said, any ideas what this is for? It was...
- Started by Jonnyfrance
- Replies: 5
-
Potterton Promax 15 HEBeen called out to an issue with a Potterton...
- Started by MethodPH
- Replies: 3
-
Best flush cones for low level cistern connections?Any recommendations other than the usual clear...
- Started by macka09
- Replies: 4
-
-
customer wants boiler in unheated storeroomunheated storeroom, with louvre doors open to...
- Started by Gasinspect
- Replies: 2
-
Seized Filling Loop TapHi, any ideas on how I can get this seized tap...
- Started by fadsarmy
- Replies: 1
-
Non-return rat flap/blocker at drain exitHi folks! I have a question re rat flaps /...
- Started by Johnfella
- Replies: 1
-
Texture metal lined pipe?Hi guys Any of you use the above pipe at all...
- Started by macka09
- Replies: 4
-
Rusted screw removal tool??Hi guys any advice on removing rusted screws...
- Started by macka09
- Replies: 0