UK Plumbers Forums | UK-specific Plumbing Advice Forum

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Questions and plumbing advice in the UK Plumbers Forums - This is the UK Plumbers Forums. Plumbing threads related to UK rules and regulations. Advice for Plumbers in the United Kingdom. Keep Gas-related advice in the Gas Engineers Forum..

Normal Threads
Hi All I have a client asking whether they can still use the AGA to heat rads once the air...
Answers
1
Views
254
Has anyone fitted an Ideal Standard i.life S 50cm compact washbasin with a matching i.life S & B...
Answers
7
Views
1K
Just was at a caravan site in Lake District recently, which had some very interesting Delabie...
Answers
2
Views
371
Any advice on selecting the best central heating flushing system would be most greatful
Answers
0
Views
246
Hi. My hot water cylinder has a small leak. It's from the immersion heater where it screws into...
Answers
3
Views
372
Answers
Views
N/A
Hi everyone, for the last few months ive had a random banging on the mains water pipe. This...
Answers
7
Views
493
What is the internal diameter of a steel pipe with external diameter of 43mm or 1.7"? Below is...
Answers
7
Views
577
I remodeled the master bath. I'm trying to put the tub spout on but having a hard time getting...
Answers
1
Views
304
Hi All, I just had a question about something I noticed. Since last week my dishwasher is not...
Answers
1
Views
313
Hi guys I have expressed an opinion on this waste plumbing which is by a builder on an extension...
Answers
3
Views
413
Good afternoon, new joiner here with a DIY (ish) question. I have a hot water cylinder with a...
Answers
5
Views
609
Does anyone know a good, not super expensive, leak detection company in the London area?
Answers
1
Views
743
I was stupid enough not to check the position of the pipes under the tiles when installing a...
Answers
1
Views
630
A
My kitchen tap has an M18x1 threaded end and I need to connect a 1/2" hose to it. Can anyone...
Answers
1
Views
320
J
Hello I have a screen default on an old drainage inspection camera? Anyone that can help...
Answers
1
Views
342
Has anyone worked on / installed one of these?
Answers
1
Views
363
Hi All, I have an undersink 3-stage water filtration system. The limescale media (resins)...
Answers
2
Views
377
    • Like
Hi, I'm fitting a shower and I have a screw in fitting for the shower rail that I want to...
Answers
6
Views
627
Hi All I hope you can help me with this slightly random question. I'm an artist and I have...
Answers
3
Views
425
D
On my kitchen sink (sink and a half) I replaced the traps and bought a pack for the 40mm pipe...
Answers
1
Views
289
Hi everyone Need advice ! My corner bathroom sink is leaking from a hole which is located at...
Answers
5
Views
405
A
Hi all - I need to replace the sacrificial anode on a small apartment block UFH buffer storage...
Answers
1
Views
307
I know of multiple estates built during the celtic tiger where the closed system heating is...
Answers
11
Views
773
J
Has anyone come across a rounded screw on a plate heat exchanger on a baxi duo tec and not been...
Answers
2
Views
377
Morning all Did anyone watch the debate last night? What did you think of it? Heat pumps and...
Answers
7
Views
596
Which manufacturer makes "full bore" radiator valves? Thanks
Answers
4
Views
520
Hello, I’m renovating a house and I can hear what sounds like water flowing through the seizes...
Answers
3
Views
471
Hello there, I'm in n desperate need to find a replacement cartridge for an old tap. It's from...
Answers
1
Views
391
Hi, I ask this question following a little DIY job to clear out my bathroom sink traps. Having...
Answers
5
Views
654
Post a New Thread / Question

New Threads

Back
Top